W7CF128M1XA-H20PC-001.01 Wintec Industries, W7CF128M1XA-H20PC-001.01 Datasheet - Page 12

• Manufacturer Part Number: W7CF128M1XA-H20PC-001.01
• Description: IC MEMORY
• Manufacturer: Wintec Industries

Specifications of W7CF128M1XA-H20PC-001.01

• Memory Size: 128M bytes
• Memory Type: CompactFLASH
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 385-1037

WintecCF-W7CF-H_v2.2 ROHS
June 2006  Wintec Industries, Inc.
INDUSTRIAL GRADE CompactFlash
W7CFxxxA-H Series ROHS 6/6 Compliant
32MB – 8-GB
Table 7: Card Pin Explanation Cont.
-REG
(PC Card Memory Mode)
-REG
(PC Card I/O Mode)
-REG
(True IDE Mode)
-RESET
(PC Card Memory Mode)
-RESET
(PC Card I/O Mode)
-RESET
(True IDE Mode)
VCC
(PC Card Memory Mode)
VCC
(PC Card I/O Mode)
VCC
(True IDE Mode)
-VS1, -VS2
(PC Card Memory Mode)
-VS1, -VS2
(PC Card I/O Mode)
-VS1, -VS2
(True IDE Mode)
Signal Name
Type
O
I
I
-
TM
Disk
13, 38
33, 40
Pin #
44
41
This signal is used during Memory Cycles to distinguish
between Common Memory and Register (Attribute) Memory
accesses. High for Common Memory, Low for Attribute
Memory.
The signal must also be active (low) during I/O Cycles when
the I/O address is on the Bus.
In True IDE Mode this input signal is not used and should be
connected to VCC by the host.
When the pin is high, this signal resets the Compact Flash
Card. The card is Reset only at power up if this pin is left
high or open from power-up. The card is also reset when the
Soft Reset bit in the Card Configuration Option Register is
set.
This signal is the same as the PC Card Memory Mode signal.
In the True IDE Mode this input pin is the active low
hardware reset from the host.
+5, +3.3V power.
This signal is the same for all modes.
This signal is the same for all modes.
Voltage Sense Signals. –VS1 is grounded so that the
Compact Flash Card CIS can be read at 3.3 volts and –VS2 is
open and reserved by PCMCIA for a secondary voltage.
This signal is the same for all modes.
This signal is the same for all modes.
Description
10