T-51511D150-FW-A-AC Optrex America Inc, T-51511D150-FW-A-AC Datasheet - Page 18

• Manufacturer Part Number: T-51511D150-FW-A-AC
• Description: LCD 15.0" TFT MOD 1024X768 XGA
• Manufacturer: Optrex America Inc

Specifications of T-51511D150-FW-A-AC

• Display Type: TFT- Thin Film Transistor
• Display Mode: Transmissive
• Viewing Area: 304.10mm L x 228.10mm W
• Dot Pitch: 0.30mm x 0.30mm
• Dot Pixels: 1024 x 768 (XGA)
• Interface: TTL
• Pixel Density: 1024 x 768
• Module Size (w X H X T): 326 mm x 255 mm x 15.5 mm
• Backlighting: CCFL White
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Backlight: -
• Dot Size: -
• Lead Free Status / Rohs Status: No
• Other names: 73-1230

(3) PRECAUTIONS WITH ELECTROSTATICS
(4) STORAGE PRECAUTIONS
(5) SAFETY PRECAUTIONS
(2) OPERATING PRECAUTIONS
j. Please connect the metal frame of LCD module to GND in order to minimize the effect of external
k. Be sure to connect the cables and the connectors correctly.
a. Please be sure to turn off the power supply before connecting and disconnecting signal input cable.
b. Please do not change variable resistance settings in LCD module. They are adjusted to the most
c. LCD backlight takes longer time to become stable of radiation characteristics in low temperature
d. A condensation might happen on the surface and inside of LCD module in case of sudden change of
e. Please pay attention not to display the same pattern for very long time. Image might stick on LCD.
f. Please obey the same safe instructions as ones being prepared for ordinary electronic products.
a. This LCD module use CMOS-IC on circuit board and TFT-LCD panel, and so it is easy to be affected
b. Please remove protection film very slowly from the surface of LCD module to prevent from
a. Please do not leave the LCDs in the environment of high humidity and high temperature such as
b. Please do not leave the LCDs in the environment of low temperature; below -20°C.
a. When you waste damaged or unnecessary LCDs, it is recommended to crush LCDs into pieces and
T-51511D150-FW-A-AC (AC) No. 2002-0229
noise and EMI.
suitable value. If they are changed, it might happen LCD does not satisfy the characteristics
specification.
than in room temperature.
ambient temperature.
Even if image sticking happens, it may disappear as the operation time proceeds.
by electrostatics. Please be careful with electrostatics by the way of your body connecting to the
ground and so on.
electrostatics occurrence.
60°C90% RH.
wash them off with solvents such as acetone and ethanol, which should later be burned.
OPTREX CORPORATION
Page 19/33