T-55468D104J-FW-A-AAN Optrex America Inc, T-55468D104J-FW-A-AAN Datasheet - Page 23

• Manufacturer Part Number: T-55468D104J-FW-A-AAN
• Description: LCD 10.4" TFT MOD 1024X768 XGA
• Manufacturer: Optrex America Inc

Specifications of T-55468D104J-FW-A-AAN

• Display Type: TFT- Thin Film Transistor
• Display Mode: Passive
• Viewing Area: *
• Dot Size: *
• Dot Pitch: *
• Dot Pixels: 1024 x 768 (XGA)
• Interface: LVDS
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Backlight: -
• Lead Free Status / Rohs Status: Details

12. HANDLING PRECAUTIONS FOR TFT-LCD MODULE
Please pay attention to the followings in handling TFT-LCD products;
(1) ASSEMBLY PRECAUTION
OPTREX
a. Please mount the LCD module by using mounting hole with a screw clamping torque less than
b. Please design display housing in accordance with the following guide lines.
c. Please do not push or scratch LCD panel surface with anything hard. And do not soil LCD panel
d. Please wipe off LCD panel surface with absorbent cotton or soft cloth in case of it being soiled.
e. Please wipe off drops of adhesives like saliva and water on LCD panel surface immediately.
f. Please do not take a LCD module to pieces and reconstruct it. Resolving and reconstructing
g. Please do not touch metal frames with bare hands and soiled gloves. A color change of the metal
h. Please handle metal frame carefully because edge of metal frame is very sharp.
i. Please pay attention to handling lead wire of backlight so that it is not tugged in connecting
j. Please connect the metal frame of LCD module to GND in order to minimize the effect of
0.3 Nm. Please do not bend or wrench the LCD module in assembling. Please do not drop, bend
or twist the LCD module in handling.
(a) Housing case must be designed carefully so as not to put stresses on LCD and not to wrench
(b) Keep sufficient clearance between LCD module back surface and housing when the LCD
surface by touching with bare hands. (Polarizer film, surface of LCD panel is easy to be flawed.)
They might damage to cause panel surface variation and color change.
modules may cause them not to work well.
frames can happen during a long preservation of soiled LCD modules.
with inverter.
external noise and EMI.
(c) When some parts, such as, FPC cable and ferrite plate, are installed underneath the LCD
(d) Design the inverter location and connector position carefully so as not to give stress to lamp
(e) Keep sufficient clearance between LCD module and the others parts, such as inverter and
(f) To avoid local elevation/decrease of temperature, considering location of heating element,
module, still sufficient clearance is required, such as 0.5mm. This clearance is, especially, to
be reconsidered when the additional parts are implemented for EMI countermeasure.
cable, or not to interfere the LCD module by the lamp cable.
module.
module is mounted. Approximately 1.0mm of the clearance in the design is recommended
taking into account the tolerance of LCD module thickness and mounting structure height
on the housing.
speaker so as not to interfere the LCD module. Approximately 1.0mm of the clearance in the
design is recommended.
heat release, thermal design should be done.
Confidential
(23/25)
T-55468D104J-FW-A-AAN