HLMP-NL06 Avago Technologies US Inc., HLMP-NL06 Datasheet - Page 11

• Manufacturer Part Number: HLMP-NL06
• Description: LED 3MM ALINGAP 590NM AMB 60DEG
• Manufacturer: Avago Technologies US Inc.

Specifications of HLMP-NL06

• Viewing Angle: 60°
• Package / Case: Radial - 2 Lead
• Color: Amber
• Millicandela Rating: 96.2mcd
• Current - Test: 20mA
• Wavelength - Dominant: 590nm
• Wavelength - Peak: 592nm
• Voltage - Forward (vf) Typ: 2.02V
• Lens Type: Clear, Amber Tinted
• Lens Style/size: Round, 3mm, T-1
• Height: 5.70mm
• Mounting Type: Through Hole
• Resistance Tolerance: 590nm
• Led Size: T-1
• Illumination Color: Amber
• Lens Color/style: Non-Diffused
• Operating Voltage: 1.9 V
• Wavelength: 600 nm
• Luminous Intensity: 90.2 mcd
• Mounting Style: Through Hole
• Color, Emitted: Amber
• Color, Lens: Clear
• Package Type: 3 mm (T-1)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Luminous Flux @ Current - Test: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 516-1769; HLMP-NL06

Package Options
Lead Option
Straight Lead
Formed Lead
AMMO PACK (for All options except #002)
TAPE & REEL (for option #002 only)
ADHESIVE TAPE MUST BE
FACING TOWARDS THE
OUTSIDE OF THE REEL.
FROM LEFT SIDE OF BOX,
ADHESIVE TAPE IS FACING
UPWARD.
DIMENSIONS IN MILLIMETERS (INCHES).
336 (13.23) DIA.
110 (4.33) DIA.
ANODE LEAD LEAVES
THE BOX FIRST.
DIMENSIONS IN MILLIMETERS (INCHES).
52 (2.05)
Ammo Pack
(1000 pcs.)
#2C —
#2U —
REELING ORIENTATION
CLOCKWISE
Tape & Reel
(2000 pcs.)
#002
–
336 (13.23)
PROTECTIVE
CARDBOARD
ANODE LEAD LEAVES
THE REEL FIRST.
Recommended Assembly Condition
• A single-sided phenolic printed circuit board (PCB) is
• If SMT devices and an adhesive are used on the same
preferred. Double-sided PCB and other materials may
cause greater lead stress. Recommended through-
hole diameter is 0.93 to 1.03 mm. Leadlength below
the PCB should be 1.5 to 2.0 mm, and the clinching
angle (angle between the lead and PCB) should be 30
±10 degrees.
pcb as these lamps, the adhesive should be cured
before the lamps are auto-inserted. If curing must
be
temperature and time should not exceed 140°C,
100 seconds. This is the temperature of the surface
normal to the IR source.
140 (5.51)
done
after
lamp
insertion,
the
cure