S82Y-J10F Omron, S82Y-J10F Datasheet - Page 5

• Manufacturer Part Number: S82Y-J10F
• Description: MOUNTNG BRAKT FRONT FOR S82J-100
• Manufacturer: Omron
• Series: S82Jr

Specifications of S82Y-J10F

• Accessory Type: Mounting Bracket(s)
• For Use With/related Products: S82J 100W Power Supplies
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: S82YJ10F

Note: 1. When a load is connected that has a built-in DC-DC converter, the overload protection may operate at startup and the power supply may
Connections
■ Block Diagrams
S82J-010@@@@ (10 W)
S82J-025@@@@ (25 W)
S82J-050@@@@ (50 W)
2. Do not use the Inverter output for the Power Supply. Inverters with an output frequency of 50/60 Hz are available, but the rise in the internal
3. Defined with a 100% load and the rated input voltage (100 or 200 VAC.)
4. The output specification is defined at the power output terminals.
5. If the output voltage adjuster (V. ADJ) is turned, the voltage will increase by more than +10% of the voltage adjustment range.
6. Refer to Overload Protection on page 10 for details.
7. For resetting, turn OFF the power, leave for more than one minute, and then turn it ON again.
8. The protection-ON alarm indicator will light as soon as the output is interrupted. For resetting, turn OFF the input power, leave for more
9. Radiated emissions: The noise value is affected by factors such as the wiring method. For 300-W and 600-W models, use shielded wire
10.The weight indicated is the weight of the open-frame type. (Includes the covers for 300-W and 600-W models)
Note: Fuse capacity: 10 W, 1 A
not start. Be sure to select a Power Supply with sufficient capacity. Refer to Overload Protection on page 10 for details.
temperature of the Power Supply may result in ignition or burning.
When adjusting the output voltage, confirm the actual output voltage from the Power Supply and be sure that the load is not damaged.
than three minutes (90 seconds min. for the 300-W models), and then turn it back ON again.
for all wiring, and insert one noise clamp filter (TDK, ZCAT3035-1330) on the input wire, and two noise clamp filters on the load wire.
Input
Input
AC (N)
AC (N)
AC (L)
AC (L)
Fuse (See note.)
Fuse (3A)
25 W, 2 A
Noise filter
Noise filter
Noise filter
Noise filter
Rectification
Rectification
Inrush current
protection circuit
Inrush current
protection circuit
Overcur-
rent
detection
circuit
Overcur-
rent
detection
circuit
Control circuit
Control circuit
Smoothing
Smoothing
Photocoupler
Photocoupler
Rectifier/
smoothing
circuit
Rectifier/
smoothing
circuit
Detection
circuit
Detection
circuit
+V
+V
−
−
DC Output
DC Output
V
V
S82J
5