HS6000EIU02H Renesas Electronics America, HS6000EIU02H Datasheet - Page 27

• Manufacturer Part Number: HS6000EIU02H
• Description: EMULATOR USB INTERFACE
• Manufacturer: Renesas Electronics America

Specifications of HS6000EIU02H

• Accessory Type: USB Interface Module
• For Use With/related Products: E6000, E6000H and E8000 Emulators
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

The problems that may occur when using the USB adapter and the measures to be taken are as
follows.
1. The HDI or High-performance Embedded Workshop will not start.
2. The HDI or High-performance Embedded Workshop stops operating.
3. The LED is lit for displaying the communication state.
If the problem is not solved even if those measures have been taken, there will be a failure in the
USB adapter. In such a case, contact Renesas’ sales agency.
If the emulator is not powered-on, an error message will be displayed when the HDI or High-
performance Embedded Workshop is started. Check that the USB adapter and emulator are
correctly connected and the emulator is powered-on.
Check that the USB adapter and emulator are correctly connected.
Check if another HDI or High-performance Embedded Workshop tries to communicate with
the USB adapter. Multiple HDIs or High-performance Embedded Workshop cannot use one
USB adapter at the same time.
The USB adapter has an LED for displaying the communication state as shown in figure 5.1.
This LED will be lit if an error occurs in the USB interface communication.
If this LED is lit after above items 1 and 2 have been checked and have no problems, turn the
emulator and the user system off, remove the USB cable from the USB adapter, and connect
them again.
Section 5 Troubleshooting
17