HS2633ECN61H Renesas Electronics America, HS2633ECN61H Datasheet - Page 18

• Manufacturer Part Number: HS2633ECN61H
• Description: DEV EMULATOR PCB ADAPTOR
• Manufacturer: Renesas Electronics America

Specifications of HS2633ECN61H

• Accessory Type: User Interface Cable
• For Use With/related Products: H8S/2633 128-QFP
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Check the location of pin 1 before inserting the MCU into the IC socket on the user system, as
shown in figure 8. After inserting the MCU, fasten the socket cover with the provided four screws
(M2 x 8 mm; with four flat washers). Take special care, such as manually securing the IC socket
soldered area, to prevent the IC socket from being damaged by overtightening the screws or twisting
the components.
12
1. Check the location of pin 1 before inserting.
2. Use a Phillips-type screwdriver whose head matches
3. The tightening torque must be 0.098 N•m or less.
4. If the MCU does not operate correctly, cracks might have
Section 3 Installing the MCU to the User System
the screw head.
If the applied torque cannot be accurately measured,
stop tightening when the force required to turn the screw
becomes significantly greater than that needed when first
tightening. If a screw is tightened too much, the screw
head may break or an IC socket contact error may be caused
by a crack in the IC socket solder.
occurred in the solder. Check conduction with a tester
and re-solder the IC socket if necessary.
CA
UTION