UM245R FTDI, Future Technology Devices International Ltd, UM245R Datasheet - Page 22

• Manufacturer Part Number: UM245R
• Description: MODULE USB-PAR FIFO TTL 24-DIP
• Manufacturer: FTDI, Future Technology Devices International Ltd

Specifications of UM245R

• Main Purpose: Interface, USB 2.0 to Parallel FIFO Bridge
• Embedded: No
• Utilized Ic / Part: FT245R
• Primary Attributes: 300kBps to 1MBps USB to parallel FIFO via 4-Wire Interface
• Secondary Attributes: Royalty-Free Drivers
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 768-1020

7.4 Bus Powered with 3.3V Logic Drive / IO Supply Voltage
Figure 7.4 USB Bus Powered 3.3V Logic Drive
Figure 7.4 shows a configuration where a jumper switch is used to allow the FT245R to be interfaced with
a 3.3V or 5V logic devices. The FT245R‟s VCCIO pin is either supplied with 5V from the USB bus (connect
together pins 2 and 3 on J1), or with 3.3V from the FT245R‟s 3V3OUT pin (connect together pins 1 and 2
on J1 as shown). The supply to UM245R‟s 3V3 pin can also be used to supply up to 50mA to external
logic.
Please note the following in relation to bus powered designs of this type:
Another possible configuration would be to use a discrete LDO which is supplied by the 5V on the USB
bus to supply 2.8V - 1.8V to the VIO pin and to the external logic. VCC would be supplied with the 5V
from the USB bus. With VIO connected to the output of the low dropout regulator would, in turn, will
cause the FT245R I/O pins to drive out at 2.8V - 1.8V logic levels.
For USB bus powered circuits some considerations have to be taken into account when selecting the
regulator:
An example of a regulator family that meets these requirements is the MicroChip MCP17xx Series of
devices (www.microchip.com). These devices can supply up to 250mA current and have a quiescent
current of under 1μA.
© Copyright 2009 Future Technology Devices International Ltd
i)
ii) The maximum current source from USB Bus during normal operation should not exceed 100mA,
iii) The regulator must be capable of sustaining its output voltage with an input voltage as low as
iv) The quiescent current of the regulator must be low in order to meet the USB suspend total
The PWREN# signal should be used to power down external logic during USB suspend mode, in
order to comply with the limit of 500μA (2.5mA with remote wake-up enabled). If this is not
possible, use the configuration shown in
otherwise a bus powered design with power switching
4.35V. A Low Drop Out (LDO) regulator must be selected.
current requirement of <= 500μA/2.5mA during USB suspend.
UM245R USB - Parallel FIFO Development Module Datasheet Version 1.04
Section 7.3
(Section
Document Reference No.: FT_000202
7.3) should be used.
Clearance No.: FTDI# 124
21