OM6274,598 NXP Semiconductors, OM6274,598 Datasheet
![DEMO BOARD I2C TO SPI SC18IS602](/photos/9/4/90470/om6274_598_sml.jpg)
OM6274,598
Manufacturer Part Number
OM6274,598
Description
DEMO BOARD I2C TO SPI SC18IS602
Manufacturer
NXP Semiconductors
Specifications of OM6274,598
Main Purpose
Interface, I2C to SPI Master
Embedded
No
Utilized Ic / Part
SC18IS602, SC18IS603
Primary Attributes
I2C to GPIO & SPI Master
Secondary Attributes
Up to 4 SPI Chip Selects
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
568-4705
935283429598
OM6274
OM6274
935283429598
OM6274
OM6274
Board Connection
-
-
-
-
I2C
SPI
Address
SC18IS602/603
o This I2C header is used to connect an I2C host such as a microcontroller
o This -INT signal is an interrupt signal output from the SC18IS602/603 to
o This -RST signal is a reset signal input to the SC18IS602/603 from the
o This SPI header is used to connect SPI slave devices. The signals need to
o If the four chip-selects are not used to select the SPI slave devices. They
o This address header is used to select an I2C address of SC18IS602/603 on
o SC18IS602 uses an internal clock so it does not require an external clock.
o SC18IS603 requires an external clock so an oscillator should be installed
with I2C bus master capability interfacing to SC18IS602/603 (I2C-to-SPI
bus controller) Bridge. The signals need to be attached to the I2C bus are
VCC, SDA, SCL, INT, RST, and GND.
the I2C host. If an interrupt method is used, the INT signal should be
connected to the input interrupt of the I2C host for servicing the interrupt
when occurred.
I2C host. The host can reset the SC18IS602/603 and upon reset, the
SC18IS602/603 registers will be initialized with the default values.
be attached to the SPI bus are VCC, MISO, MOSI, SCLK, GND. The four
chip selects (SSO, SS1, SS2, SS3) need to be connected to the SPI slave
devices so one chip select is for one SPI slave device. Thus, up to four SPI
slave devices can be connected to the SC18IS602/603
can be used for general-purpose input/output (GPIO). Peripherals such as
LEDs and switches can be connected to the GPIO. The programmable
GPIO can drive LEDs as output from the SC18IS602/603 and detect
switches as input to the SC18IS602/603.
the I2C-bus. The SC18IS602/603 has three bit addresses (A0, A1, A2) so
8 different addresses can be selected and the host can identify the
SC18IS602/603 with its I2C address.
An oscillator installed on the OSC1 location should be removed.
on the OSC1 location.
SC18IS602/603 Demo Board
Related parts for OM6274,598
OM6274,598 Summary of contents
Page 1
SC18IS602/603 Demo Board Board Connection - I2C o This I2C header is used to connect an I2C host such as a microcontroller with I2C bus master capability interfacing to SC18IS602/603 (I2C-to-SPI bus controller) Bridge. The signals need to be attached ...
Page 2
The block diagram below shows an example of the SC18IS602/603 as I2C-to-SPI bus Bridge for a serial interface application between a host processor with I2C master interface capability and multiple SPI slave devices The host with I2C master interface capability ...