IS-DEV KIT-5C NKK Switches, IS-DEV KIT-5C Datasheet - Page 10

• Manufacturer Part Number: IS-DEV KIT-5C
• Description: SMARTSWITCH DEVELOPMENT KIT 5C
• Manufacturer: NKK Switches
• Series: SmartSwitch™r

Specifications of IS-DEV KIT-5C

• Main Purpose: Switches with Programmable Display
• Utilized Ic / Part: IS15SBFP4RGB
• Primary Attributes: 2 LCD Switches, PC Board with Flash Memory
• Secondary Attributes: Power and Programming Connections
• Description/function: SMARTSWITCH Development Kit
• For Use With: 360-2431 - SERIAL CBL RJ11-DB9 FOR DEV KIT360-2430 - POWER SUPPLY 240VAC FOR DEV KIT360-2429 - POWER SUPPLY 120VAC FOR DEV KIT
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Embedded: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: Smart Switch - RGB
• Other names: 360-2327; IS-DEV KIT-4

7850 East Gelding Drive • Scottsdale, AZ 85260-3420
[Address] is one byte with value of 01H to FFH sent as ASCII HEX format.
[Legend Block] is 125 bytes in LCD 36x24 mode and is 256 bytes in LCD 64x32 mode transmitted in ASCII
HEX format.
The controller disables the timers and switch execution upon receiving this command. However, the switches
are still scanned and reported. They are enabled upon reboot/power up or by command from host.
Command to upload a Legend block
[Address] is one byte with value of 01H to FFH sent as ASCII HEX format.
The controller transmits back the image (125 bytes in LCD 36x24 mode and is 256 bytes in LCD 64x32
mode) in HEX format.
The controller disables the timers and switch execution upon receiving this command. However, the switches
are still scanned and reported. They are enabled upon reboot/power up or by command from host.
Command to download attribute block
[Address] is one byte with value of 01H to FFH sent as ASCII HEX format.
[Attribute Block] is six bytes in LCD 36x24 mode and is eight bytes in LCD 64x32 mode transmitted in
ASCII HEX format.
The controller disables the timers and switch execution upon receiving this command. However, the switches
are still scanned and reported. They are enabled upon reboot/power up or by command from host.
Command to upload an attribute block
[Address] is one byte with value of 01H to FFH sent as ASCII HEX format.
[Attribute Block] is six bytes in LCD 36x24 mode and is eight bytes in LCD 64x32 mode transmitted in
ASCII HEX format.
The controller transmits back the [Attribute block] in hex format.
IS-Dev Kit-5 and IS-Dev Kit-6 Users Manual A.doc
This command uploads a Legend block from the EEPROM location to the host.
This command downloads an attribute block from the host to the EEPROM location.
This command uploads an attribute block from the EEPROM location to the host.
command format:
transmit format:
command format: 2AH [Address] [Attribute Block]
transmit format:
command format: 2BH [Address]
transmit format:
Toll Free 1.877.2BUYNKK (877.228.9655) • Phone [phone] • Fax [phone]
(xxH)
(xxH)
(xxH)
29H
IS-Dev Kit-5 and IS-Dev Kit-6 Users
www.nkkswitches.com • Email [e-mail]
[Address]
(xxAH)
(xxAH)
(xxAH)
Manual
(xxAH)
Page 10 of 24
1209