EVB-USB2524 SMSC, EVB-USB2524 Datasheet - Page 9

• Manufacturer Part Number: EVB-USB2524
• Description: BOARD EVAL USB2524 SHARE/SWITCH
• Manufacturer: SMSC
• Series: MultiSwitch™r

Specifications of EVB-USB2524

• Main Purpose: Interface, USB 2.0 Hub
• Embedded: No
• Utilized Ic / Part: USB2524
• Primary Attributes: Quad Port Hub, High Speed (480Mbps), SMBus
• Secondary Attributes: Overcurrent Protection, Port Power Switching, Multi-TT Enabled
• Interface Type: USB
• Operating Supply Voltage: 5 V
• Product: Interface Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: USB2524
• Other names: 638-1044

USB MultiSwitch
Datasheet
SMSC USB2524
1.1
A default configuration is available in the USB2524 following a reset. This configuration may be
sufficient for some applications. Strapping option pins make it possible to modify a limited sub-set of
the configuration options.
The USB2524 may also be configured by an external EEPROM or a microcontroller. When using the
microcontroller interface, the Hub appears as an SMBus slave device. If the Hub is pin-strapped for
external EEPROM configuration but no external EEPROM is present, then a value of ‘0’ will be written
to all configuration data bit fields (the hub will attach to the host with all ‘0’ values).
The USB2524 supports several OEM selectable features:
OEM Selectable Features
TM
Hub
Optional OEM configuration via I2C EEPROM or via the industry standard SMBus interface from
an external SMBus Host or Microcontroller.
Compound device support (port is permanently hardwired to a downstream USB peripheral device).
Hardware strapping options enable configuration of the following features (when not configured via
an EEPROM or SMBus host).
Selection of Single (STT) or Multi-Transaction Translator (MTT) capability.
Selection of Over-Current sensing and Port power control on a individual (port-by-port) or ganged
(all ports together) to match the OEM’s choice of circuit board component selection.
Selection of end-user method of switching ports between hosts
Internal default settings).
selectable between edge triggered operation or level triggered operation for compatibility with many
different mechanical switch configurations or direct control from an external Microcontroller’s GPIO
pins.
Enablement of String Descriptor Support, along with the capability to customize each of the 3
different string descriptors (up to a maximum size of 31 characters each)
Selection of LED Mode: USB Mode, Host Ownership Mode, or Host Ownership Mode with Speed
Indication.
Non-Removable Ports
Port Power Polarity (active high or active low logic)
-Embedded Mode: 8 default configurations that are controlled by OEM programmable registers (or
-Peripheral Mode: Each wire directly controls one of the 4 downstream ports. The interface is
DATASHEET
9
Revision 1.91 (08-22-07)