IS-DEV KIT-7 NKK Switches, IS-DEV KIT-7 Datasheet - Page 13

• Manufacturer Part Number: IS-DEV KIT-7
• Description: KIT DEV FOR OLED SWITCH
• Manufacturer: NKK Switches
• Series: SmartSwitch™r

Specifications of IS-DEV KIT-7

• Main Purpose: Switches with Programmable Display
• Embedded: Yes, ASIC
• Utilized Ic / Part: ISC15ANP4
• Primary Attributes: 2 OLED Switches, PC Board with Flash Memory
• Secondary Attributes: Power and Programming Connections
• Description/function: SMARTSWITCH Development Kit
• For Use With: 360-2431 - SERIAL CBL RJ11-DB9 FOR DEV KIT360-2430 - POWER SUPPLY 240VAC FOR DEV KIT360-2429 - POWER SUPPLY 120VAC FOR DEV KIT
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• For Use With/related Products: Smart Switch - OLED
• Other names: 360-2339

7850 East Gelding Drive • Scottsdale, AZ 85260-3420
The controller disables the timers and switch execution upon receiving this command. However, the switches
are still scanned and reported. They are enabled upon reboot/power up or by command from host.
Command to upload an image
[address] is two bytes with value of 0001H to FFFFH sent as ASCII HEX format.
The controller transmits back the image (6144 bytes) in HEX format.
The controller disables the timers and switch execution upon receiving this command. However, the switches
are still scanned and reported. They are enabled upon reboot/power up or by command from host.
Command to download attribute block
[address] is two bytes with value of 0001H to FFFFH sent as ASCII HEX format.
[attribute block] is eight bytes transmit in ASCII HEX format.
The address and attribute block are saved at this address. When the controller reads the attribute block it
compares the requested address to the saved address and if they do not match controller knows that the
attribute block is not programmed and ignores it.
The controller disables the timers and switch execution upon receiving this command. However, the switches
are still scanned and reported. They are enabled upon reboot/power up or by command from host.
Command to upload an attribute block
[address] is two bytes with value of 0001H to FFFFH sent as ASCII HEX format.
The controller transmits back the saved address and [Attribute block] in hex format.
The controller disables the timers and switch execution upon receiving this command. However, the switches
are still scanned and reported. They are enabled upon reboot/power up or by command from host.
CL01 Intelligent Controller Users Manual B.doc
This command uploads an image from the microSD location to the host.
This command downloads an attribute block from the host to the EEPROM location.
This command uploads an attribute block from the EEPROM location to the host.
command format:
transmit format:
command format: 2AH [address] [attribute block]
transmit format:
command format: 2BH [address]
transmit format:
Toll Free 1.877.2BUYNKK (877.228.9655) • Phone [phone] • Fax [phone]
CL01 Intelligent Controller Users Manual
(xxH) (xxAH)
(xxH) (xxAH)
(xxH) (xxAH)
29H
www.nkkswitches.com • Email [e-mail]
[address]
(xxAH)
Page 13 of 24
0110