MAX16046EVKIT+ Maxim Integrated Products, MAX16046EVKIT+ Datasheet - Page 3

• Manufacturer Part Number: MAX16046EVKIT+
• Description: IC EE-PROG SYS MGR 12CH 56-TQFN
• Manufacturer: Maxim Integrated Products

Specifications of MAX16046EVKIT+

• Main Purpose: Power Management, Power Supply Supervisor/Tracker/Sequencer
• Utilized Ic / Part: MAX16046, MAX16048
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Secondary Attributes: -
• Embedded: -
• Primary Attributes: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

1) Ensure jumper J1 is set to LOW. Also ensure that
2) Connect the MAX16046 EV kit to a PC using the
3) Install the MAX16046 EV kit software.
4) Launch MAX16046.exe.
5) Select I2C in the Connect dialog, and make sure
6) From the File menu, select Open Configuration.
7) Select the MAX16046 EV Kit Demo.xml file and click
Figure 1. Connect Dialog
Figure 2. Setup Tab
jumpers J2, J3, and J4 are set to the 1-2 position, J5
and J6 are closed, J7 and J8 are in the 2-3 position,
and J100 is in the 3.3V position. All switches in switch
banks S1, S2, and S3 should be in the ON position.
provided USB cable. LED100 will light, indicating
that the EV kit has power.
Address is 0xA0. Click OK.
OK. This action loads the Setup tab with a configu-
ration that matches the power supplies on the
_______________________________________________________________________________________
Procedure
MAX16046 Evaluation Kit
8) Click the Data Logging tab. Move the enable
The MAX16046 EV kit software serves two purposes.
One is to facilitate evaluation of the MAX16046 on the
EV kit hardware. The other is to provide a convenient
way to configure a MAX16046–MAX16049 in an appli-
cation circuit.
Make sure the EV kit is connected to the PC by the USB
cable. Launch the software, and in the Connect dialog,
select I2C or JTAG and click OK. If the software is
being used without the EV kit connected, select Demo.
The I
0xA0, but other values (depending on the settings of
jumper J1; see Table 5) may be used.
The Setup tab, shown in Figure 2, contains information
about the power supplies connected to and monitored
by the MAX16046. Each list item represents a power
supply that is being controlled and monitored by the
MAX16046. List items may have subitems, which are
additional power-supply outputs that also require moni-
toring. For example, a dual-output DC-DC converter can
have one subitem to monitor the extra DC-DC output.
The contents of the Setup tab should match the
schematic of the application circuit. In the case of the
EV kit, the contents of the Setup tab should match the
power supplies provided with the EV kit. Figure 2 shows
the configuration for the four EV kit power supplies.
Table 1 describes the purpose of each column in the
Setup tab.
Detailed Description of Software
MAX16046 EV kit, as well as the register contents
for the MAX16046.
switch, S5, to the ON position and note the moni-
tored voltages.
2
C slave address may be specified. The default is
Connecting to the MAX16046 EV Kit
Setup Tab
3