LM5007SD-EVAL National Semiconductor, LM5007SD-EVAL Datasheet - Page 7

• Manufacturer Part Number: LM5007SD-EVAL
• Description: EVALUATION BOARD FOR LM5007SD
• Manufacturer: National Semiconductor

Specifications of LM5007SD-EVAL

• Main Purpose: DC/DC, Step Down
• Outputs And Type: 1, Non-Isolated
• Voltage - Output: 10V
• Current - Output: 400mA
• Voltage - Input: 12 ~ 75V
• Regulator Topology: Buck
• Board Type: Fully Populated
• Utilized Ic / Part: LM5007
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Power - Output: -
• Frequency - Switching: -
• Other names: *LM5007SD EVAL; *LM5007SD-EVAL; LM5007SD EVAL; LM5007SDEVAL; LM5007SDEVAL

Over-Voltage Comparator
The over-voltage comparator is provided to protect the output
from overvoltage conditions due to sudden input line voltage
changes or output loading changes. The over-voltage com-
parator monitors the FB pin versus an internal 2.875V refer-
ence (OV_REF). If the voltage at FB rises above OV_REF the
comparator immediately terminates the buck switch on time
pulse.
FIGURE 1. Low Ripple Output Configuration
FIGURE 2. Self Biased Configuration
7
ON Time generator and Shutdown
The on time of the LM5007 is set inversely proportional to the
input voltage by an external resistor connected between Ron
and Vin. The Ron terminal is a low impedance input biased at
approximately 1.5V. Thus the current through the resistor and
into the Ron terminal is approximately proportional to Vin and
used internally to control the on timer. This scheme of input
voltage feed-forward hysteretic operation achieves nearly
constant operational frequency over varying line and load
conditions. The on time equation for the LM5007 is :
20078306
20078305
www.national.com