MCP6XXXEV-AMP1 Microchip Technology, MCP6XXXEV-AMP1 Datasheet - Page 12

• Manufacturer Part Number: MCP6XXXEV-AMP1
• Description: BOARD AMPLIFIER EVAL 1 MCP6XXX
• Manufacturer: Microchip Technology

Specifications of MCP6XXXEV-AMP1

• Channels Per Ic: 1 - Single
• Amplifier Type: General Purpose
• Board Type: Partially Populated
• Utilized Ic / Part: 8-DIP Package
• Processor To Be Evaluated: MCP6xxx
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Operating Temperature: -
• Output Type: -
• Current - Output / Channel: -
• Voltage - Supply, Single/dual (±): -
• -3db Bandwidth: -
• Slew Rate: -
• Current - Supply (main Ic): -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

MCP6XXX Amplifier Evaluation Board 1 User’s Guide
DS51667A-page 8
The power supply voltage should be in the allowed range for the installed op amps. Any
of Microchip’s op amps that operate below 5.5V can be used. Moreover, power supply
is protected by a zener diode with nominal voltage 6.2V and bypassed by a 1.0 µF
capacitor. (See Figure 2-3: “Power Supply Block.”)
The mid-supply reference consists of a voltage divider and a buffer amplifier. (See
Figure 2-4: “Mid-Supply Reference Block.”)
The resistors and capacitors that are part of an amplifier are placed in pin sockets
which are labeled. All of the component labels on board keep consistent with those on
schematic generated in the Mindi™ Amplifier Designer. The op amps are bypassed by
0.1 µF capacitors and the single op amp U1 can have either a PDIP-8 or SOIC-8
package.
• PDIP-8 packages are inserted into the DIP-8 socket to the right of the U1 label
• SOIC-8 packages can be accommodated; see Section 2.4.3 “Amplifier
The (surface mount) test points for power supply, ground, input signal and output signal
allow lab equipment to be connected to the board. The MCP6XXX Amplifier Evaluation
Board 1 top view is shown in Figure 2-2.
FIGURE 2-2:
Modification: Using 8-Pin SOIC Op Amps”
MCP6XXX Amplifier Evaluation Board 1 Top View.
© 2007 Microchip Technology Inc.