STEVAL-MKI030V1 STMicroelectronics, STEVAL-MKI030V1 Datasheet - Page 50

• Manufacturer Part Number: STEVAL-MKI030V1
• Description: BOARD DEMO STM8S207R6/LIS331DLH
• Manufacturer: STMicroelectronics
• Series: MEMSr

Specifications of STEVAL-MKI030V1

• Design Resources: STEVAL-MKI030V1 Schematic
• Sensor Type: Accelerometer, 3 Axis
• Sensing Range: ±2g, 4g, 8g
• Interface: I²C, SCI
• Sensitivity: 3.9mg/digit, 2mg/digit, 1mg/digit
• Voltage - Supply: 4.5V
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: LIS331DLH, STM8S207R6T6
• Sensing Axis: Triple Axis
• Operating Voltage: 5 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 497-8852

Option bytes
50/105
Table 13.
Option byte no.
OPT3
OPT4
OPT5
OPT6
OPT7
Option byte description (continued)
LSI_EN: Low speed internal clock enable
IWDG_HW: Independent watchdog
WWDG_HW: Window watchdog activation
WWDG_HALT: Window watchdog reset on halt
EXTCLK: External clock selection
CKAWUSEL: Auto wakeup unit/clock
PRSC[1:0] AWU clock prescaler
HSECNT[7:0]: HSE crystal oscillator stabilization time
Reserved
WAITSTATE Wait state configuration
0: LSI clock is not available as CPU clock source
1: LSI clock is available as CPU clock source
0: IWDG Independent watchdog activated by software
1: IWDG Independent watchdog activated by hardware
0: WWDG window watchdog activated by software
1: WWDG window watchdog activated by hardware
0: No reset generated on halt if WWDG active
1: Reset generated on halt if WWDG active
0: External crystal connected to OSCIN/OSCOUT
1: External clock signal on OSCIN
0: LSI clock source selected for AWU
1: HSE clock with prescaler selected as clock source for for AWU
00: 24 MHz to 128 kHz prescaler
01: 16 MHz to 128 kHz prescaler
10: 8 MHz to 128 kHz prescaler
11: 4 MHz to 128 kHz prescaler
This configures the stabilisation time.
0x00: 2048 HSE cycles
0xB4: 128 HSE cycles
0xD2: 8 HSE cycles
0xE1: 0.5 HSE cycles
This option configures the number of wait states inserted when reading
from the Flash/data EEPROM memory.
1 wait state is required if f
0: No wait state
1: 1 wait state
Doc ID 14733 Rev 11
CPU
Description
> 16 MHz.
STM8S207xx, STM8S208xx