STEVAL-MKI032V1 STMicroelectronics, STEVAL-MKI032V1 Datasheet - Page 10

• Manufacturer Part Number: STEVAL-MKI032V1
• Description: BOARD DEMO ACCELEROMETER DIL24
• Manufacturer: STMicroelectronics
• Series: MEMSr

Specifications of STEVAL-MKI032V1

• Design Resources: STEVAL-MKI032V1 Schematic STEVAL-MKI032V1 Gerber Files STEVAL-MKI032V1 Bill of Materials
• Sensor Type: Accelerometer, 3 Axis
• Sensing Range: ±2.3g, 9.2g
• Interface: I²C, SPI
• Sensitivity: 18 ~ 72 mg/Digit
• Embedded: No
• Utilized Ic / Part: STM32 and MEMS Demo Boards
• Interface Type: SPI, I2C
• For Use With: 497-6048 - BOARD EVALUATION FOR STM32
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Voltage - Supply: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 497-9047

System setup
5.1.2
5.1.3
10/42
Figure 5.
Setup for analog MEMS
Position the JP1, JP2 and JP3 jumpers on the STM32-MEMS board. No modification is
needed on the STM3210B-EVAL board.
Figure 6.
Setup for digital MEMS - SPI interface
Position the JP7 jumper on the STM32-MEMS board.
If Int1 signal is used
Position the JP10 jumper on the STM32-MEMS board.
The CN13-14 pin of the STM3210B-EVAL is also used by the right joystick. If the joystick is
required, remove R75 from the STM3210B-EVAL board.
If Int2 signal is used
Position the JP11 jumper on the STM32-MEMS board.
STM3210B-EVAL board with STM32-MEMS board connected
Setup for analog MEMS
Doc ID 15703 Rev 1
UM0701