MCP9800DM-DL Microchip Technology, MCP9800DM-DL Datasheet - Page 13

• Manufacturer Part Number: MCP9800DM-DL
• Description: BOARD DEMO FOR MCP9800
• Manufacturer: Microchip Technology

Specifications of MCP9800DM-DL

• Sensor Type: Temperature
• Sensing Range: -55°C ~ 125°C
• Interface: I²C, SMBus
• Sensitivity: ±0.5°C
• Voltage - Supply: 2.7 V ~ 5.5 V
• Embedded: Yes, MCU, 8-Bit
• Utilized Ic / Part: MCP9800
• Processor To Be Evaluated: MCP9800
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Contains lead / RoHS non-compliant

© 2005 Microchip Technology Inc.
2.3.2
3. Download and install the PICkit™ 1 Flash Starter Kit software to your PC.
4. Copy the 00083R1.HEX file supplied on the CD that came with this kit to your
5. When the PICkit™ 1 Flash Starter Kit is started, the main window will be
FIGURE 2-4:
6. Toggle device power to off by unchecking the Device Power box under Board
7. Click on the Erase button in the window to ensure that the PIC16F684 device has
8. From the File pull down menu, select Import HEX. A file window will appear.
9. Click on the Write Device button in the PICkit™ 1 Flash Starter Kit window. The
10. Toggle the device power on by checking the Device Power box under Board
11. The PICmicro microcontroller starts measuring temperature and storing the data
Note:
Note:
PC.
displayed on the PC as indicated in Figure 2-4.
Controls in the PICkit™ 1 Flash Starter Kit window (Figure 2-4). The BUSY LED
on the PICkit™ 1 Flash Starter Kit board will turn off when the device power is
turned off.
been erased.
Select and Open 00083R1.HEX.
PIC16F684 device will be written to with the MCP9800 00083R1.HEX firmware.
Once completed, the status bar at the bottom of the window will indicate Write
Successful.
Controls in the PICkit™ 1 Flash Starter Kit window. The BUSY LED on the
PICkit™ 1 Flash Starter Kit board will turn on when device power is turned on.
in the EEPROM.
Programming the PIC16F684
The PIC16F684 firmware is factory programmed with 00083R1.HEX,
therefore, it is not necessary to program it out of the box.
The J2 connector can be used to program the PICmicro microcontroller
using PICkit™ 2 Microcontroller Programmer.
PICkit™ 1 Flash Starter Kit GUI Window on the PC.
DS51593A-page 9