STM3210B-EVAL STMicroelectronics, STM3210B-EVAL Datasheet - Page 49
![BOARD EVALUATION FOR STM32](/photos/9/20/92058/497-6048-nd_sml.jpg)
STM3210B-EVAL
Manufacturer Part Number
STM3210B-EVAL
Description
BOARD EVALUATION FOR STM32
Manufacturer
STMicroelectronics
Type
MCUr
Specifications of STM3210B-EVAL
Contents
Fully Assembled Evaluation Board
Processor To Be Evaluated
STM32F10x
Data Bus Width
32 bit
Interface Type
USB
Operating Supply Voltage
5 V
Silicon Manufacturer
ST Micro
Core Architecture
ARM
Core Sub-architecture
Cortex - M3
Silicon Core Number
STM32
Silicon Family Name
STM32F1xx
For Use With/related Products
STM32
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
497-6048
UM0435
4.2
Programming the M25P64 Flash memory
To program the Flash memory, go through the following steps:
1.
2.
3.
4.
Figure 62. Programming the Flash memory
Load the DFU firmware project using your preferred Toolchain and load the DFU image
using JTAG for the first time.
Connect the STM3210B-EVAL board to the PC with a USB cable. The first time this is
done, you will be asked to install a driver for the board. The driver is already available in
the installation directory.
Hold down the Key push-button on the STM3210B-EVAL board to enter the DFU mode.
Run the DfuSeDemo.exe program
In the Action (Select Target(s)) field, select SPI Flash: M25P64 and in the Upgrade
or Verify Action field, click on the Choose... button as shown in
Doc ID 13534 Rev 5
Demonstration programming using the DFU
Figure
62.
49/57