DM180021 Microchip Technology, DM180021 Datasheet - Page 20

• Manufacturer Part Number: DM180021
• Description: KIT STARTER MPLAB FOR PIC18F MCU
• Manufacturer: Microchip Technology
• Series: MPLAB®r
• Type: MCUr

Specifications of DM180021

• Contents: Board, Cable, CD
• Processor To Be Evaluated: PIC18F46J50
• Processor Series: PIC18F
• Interface Type: SPI
• Operating Supply Voltage: 3.3 V
• Silicon Manufacturer: Microchip
• Core Architecture: PIC
• Core Sub-architecture: PIC18
• Silicon Core Number: PIC18F
• Silicon Family Name: PIC18F4xxx
• Kit Contents: Board
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: PIC18Fxxxx
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

MPLAB Starter Kit for PIC18F User’s Guide
3.1
DS51852A-page 16
SETTING UP AN EXAMPLE APPLICATION FOR DEBUG
Once the starter kit software is installed, the on-board debugger must be connected to
any available USB port on the PC or powered hub, then to the starter kit at the mini-B
receptacle, J2, on the debugger/programmer side of the board (Figure 3-1). At the
same time, a sequence of pop-up balloons in the system tray (lower right of desktop)
will appear, stating that (1) new hardware has been found, (2) drivers are being
installed and (3) the new hardware is ready for use. If you do not see these messages
and the starter kit does not work, try unplugging and reconnecting the USB. If this does
not work, refer to Section 3.9 “Troubleshooting”.
FIGURE 3-1:
If you debug a USB device application, a second USB cable must be connected to
another USB port on the PC or power hub, then to the starter kit at the mini-B
receptacle, J3, on the application side of the board (Figure 3-2).
FIGURE 3-2:
CONNECTING THE STARTER KIT
DEBUGGER/PROGRAMMER
DEBUGGING A USB APPLICATION ON THE STARTER KIT
© 2009 Microchip Technology Inc.
Starter Kit
A to mini-B USB Cable
Starter Kit
A to mini-B USB Cables
M
M