702065 Spectrum Digital Inc, 702065 Datasheet - Page 35

• Manufacturer Part Number: 702065
• Description: MODULE EVAL FOR DM355
• Manufacturer: Spectrum Digital Inc
• Series: DaVinci™r
• Type: MCUr

Specifications of 702065

• Contents: Board, Batteries, Cables, CD, Power Supply, Remote
• Operating Frequency: 216 MHz
• Interface Type: RS-232, Ethernet, USB, JTAG
• Operating Supply Voltage: 5 V
• Board Size: 127 mm x 165 mm
• Software: Software Included
• Silicon Family Name: DaVinci - TMS320DM35x
• Core Architecture: C6000
• Core Sub-architecture: ARM9 / DSP
• Ic Product Type: Digital Video Evaluation Module
• For Use With/related Products: TMS320DM355
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

3.2.9 J10, USB ID Select
3.2.10 J11, S-Video In
The J10 jumper is used to allow the cable to configure the ID pin on the DM355. This is
used for the “USB On The Go” mode. When the jumper is shorted, access to the ID is
provided. The open and shorted position are shown below.
Connector J11 is a four pin mini din connector which interfaces to the TVP5146
encoder. This connector brings in a video signal (LUMA) to pin 9 on the TVP5146.
Do NOT plug into this connector with the power on. The figure below shows this
connector as viewed from the card edge.
Figure 3-10, J11, Front View, Mini Din Connector
Table 11: J11, Video In, Mini Din Connector
Figure 3-9, J10, USB ID Select
Open
Pin 1
Pin 3
J10
Pin #
1
2
3
4
Position
Shorted
Open
Table 10: J10, USB ID Select
USB ID
Signal Name
Chroma
ID controlled from GIO2
LUMA
ID from USB connector
GND
GND
Function
Pin 4
Pin 2
Shorted
J10
USB ID
Spectrum Digital, Inc
3-11