100-3020 Bluetechnix, 100-3020 Datasheet - Page 24

• Manufacturer Part Number: 100-3020
• Description: KIT BLACKFIN STARTER CM-BF537E
• Manufacturer: Bluetechnix
• Type: DSPr

Specifications of 100-3020

• Contents: Board, Module, Power Supply
• For Use With/related Products: ADSP-BF537 Blackfin® Processor
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Due to the limited number of pins on the two connectors, the CM-BF561 can only set its boot mode on the core
module itself by changing the resistor settings. See the CM-BF561 manual for further details.
7 Using a Core Module with on board USB
If you use a Core Module with USB feature, for example the CM-BF527 set switch 4 of S2 to “on”. This connects the
5.0V pin of the USB connector X9 to pin 53 of the Core Module.
If you do not use a Core Module with on board USB feature the switch 4 of S2 should always remain “off”.
8 Installation
8.1 Initial Board Setup
DEV-BF5xxDA-lite V5.x Hardware User Manual
The installation guide is written for Windows (Windows 2000 and WinXP). However for connecting the USB
device the drivers for MAC and LINUX are available on the CD.
In order to set up und test the board the follow the next steps:
1.
2.
3.
4.
Make sure the Jumper JP1 and JP2 are set and the switch S4 is in position 0 as shown in Figure 8-1 .
Set switch S2 according chapter 5.2 and 6. Set switch S1 according chapter 5.1.
Connect the power supply to the power connector of the DEV-BF5xxDA-Lite board.
Connect the DEV-BF5xxDA-Lite Board via USB to the PC. The pre-flashed BLACKSheep starts and the LED
mounted on the EVAL board starts blinking. On the PC usually the ‘Found New Hardware Wizard’ opens.
Figure 8-1: Setup of the DEV-BF5xxDA-Lite Board
23