101-0359 Rabbit Semiconductor, 101-0359 Datasheet - Page 18
![KIT DEVELOPMENT BASIC RABBIT2000](/photos/9/24/92474/101-0359_sml.jpg)
101-0359
Manufacturer Part Number
101-0359
Description
KIT DEVELOPMENT BASIC RABBIT2000
Manufacturer
Rabbit Semiconductor
Series
RabbitCore 2000r
Type
MPU Moduler
Datasheet
1.101-0359.pdf
(54 pages)
Specifications of 101-0359
Rohs Status
RoHS non-compliant
Contents
RabbitCore Module, Dev. Board, AC Adapter, Cable and Dynamic C® CD-Rom
Processor To Be Evaluated
Rabbit 2000
Interface Type
RS-232, RS-485
For Use With/related Products
RCM2000, RCM2010, RCM2020
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
316-1003
2.4 Start Dynamic C
Once the BL1810 is connected as described in Section 2.3,
ing on the Dynamic C icon or by double-clicking on dcrabXXXX.exe in the Dynamic C root
directory, where XXXX are version-specific characters
If you are using a USB port to connect your computer to the BL1810, choose
Project Options
tab.
2.5 Run a Sample Program
Find the file
open it with the
then run it by selecting
play a small square bouncing around in a box.
This program shows that the CPU is working.
2.5.1 Troubleshooting
If Dynamic C appears to compile the BIOS successfully, but you then receive a communi-
cation error message when you compile and load the sample program, it is possible that
your PC cannot handle the higher program-loading baud rate. Try changing the maximum
download rate to a slower baud rate as follows.
• Locate the
If a program compiles and loads, but then loses target communication before you can
begin debugging, it is possible that your PC cannot handle the default debugging baud
rate. Try lowering the debugging baud rate as follows.
• Locate the
If there are any other problems:
• Check to make sure you are using the
• Check both ends of the programming cable to ensure that they are firmly plugged into
• Ensure that the BL1810 is firmly and correctly installed in its connectors on the
• Select a different COM port within Dynamic C. From the Options menu, select
14
Communications
Communications
programming cable.
the PC and the programming port on the BL1810.
Prototyping Board.
Project Options, then select Communications. Select another COM port from the
list, then click OK. Press <Ctrl-Y> to force Dynamic C to recompile the BIOS. If
Dynamic C still reports it is unable to locate the target system, repeat the above steps until
you locate the active COM port.
PONG.C
Serial Options
Serial Options
File
and select “Use USB to Serial Converter” under the
menu (if it is not still open), compile it using the
, which is in the Dynamic C
menu. Select a slower Max download baud rate.
menu. Choose a lower debug baud rate.
Run
in the
dialog in the Dynamic C
dialog in the Dynamic C
Run
menu. The
PROG
connector, not the
.
SAMPLES
STDIO
Options > Project Options >
Options > Project Options >
window will open and will dis-
start Dynamic C by double-click-
folder. To run the program,
Rabbit 2000 Development Kit
DIAG
Compile
Communications
connector, on the
Options >
menu, and