101-0523 Rabbit Semiconductor, 101-0523 Datasheet - Page 54

• Manufacturer Part Number: 101-0523
• Description: KIT DEV RABBIT3000/RCM3000
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 3000r
• Type: MPU Moduler

Specifications of 101-0523

• Rohs Status: RoHS non-compliant
• Contents: RabbitCore Module, Dev. Board, AC Adapter, Cable and Dynamic C® CD-Rom
• Processor To Be Evaluated: RCM3000
• Interface Type: RS-232, Ethernet
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: - 40 C
• Operating Supply Voltage: 3.15 V to 3.45 V
• For Use With/related Products: RCM3000
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 316-1017

6.10 Run the PINGME.C Sample Program
Connect the crossover cable from your computer’s Ethernet port to the RCM3000 board’s
RJ-45 Ethernet connector. Open this sample program from the
folder, compile the program, and start it running under Dynamic C. When the program
starts running, the green
Ethernet connection is made. (Note: If the
crossover cable, or if you are using a hub perhaps the power is off on the hub.)
The next step is to ping the board from your PC. This can be done by bringing up the MS-
DOS window and running the pingme program:
or by
and typing the entry
Notice that the red
place, and indicates the transfer of data. The ping routine will ping the board four times
and write a summary message on the screen describing the operation.
6.11 Running More Sample Programs With Direct Connect
The sample programs discussed here are in the Dynamic C
folder.
•
•
•
•
46
BROWSELED.C
Two “LEDs” are created on the Web page, with two buttons to toggle them. Users can
change the status of the lights from the Web browser. The LEDs on the Prototyping
Board match the ones on the Web page. As long as you have not modified the
TCPCONFIG 1
Web browser to bring up the Web page served by the sample program.
Otherwise use the TCP/IP settings you entered in the
ECHOCLIENT.C
wait for the connected server to echo it back. After every number of sends and receives,
transfer times are shown in the
Use
ECHOSERVER.C
server that will echo back any data sent from a connected client.
Use
ENET_AD.C
gle-board computers. The program sends an A/D voltage value to the second controller
via Ethernet for display.
Use
http://10.10.6.100.
Start > Run
ping 10.10.6.100
ping 10.10.6.100
ECHO_SERVER.C
ECHO_CLIENT.C
ENET_MENU.C
—This program demonstrates Ethernet communication between two sin-
—This program demonstrates a basic controller running a Web page.
macro in the sample program, enter the following server address in your
ACT
—This program demonstrates a basic client that will send a packet and
—This program demonstrates This program demonstrates a basic
to program the other single-board computer.
light flashes on the RCM3000 board while the ping is taking
LNK
to program a server controller.
to program a client controller.
light on the RCM3000 board should be on to indicate an
STDIO
window.
LNK
light does not light, you may not have a
TCP_CONFIG.LIB
SAMPLES\RCM3000\TCPIP\
SAMPLES\TCPIP\ICMP
RabbitCore RCM3000
library.