101-0577 Rabbit Semiconductor, 101-0577 Datasheet - Page 40

• Manufacturer Part Number: 101-0577
• Description: KIT DEV FOR BL2500 COYOTE
• Manufacturer: Rabbit Semiconductor
• Series: Coyoter
• Type: Single Board Computers (SBC)r

Specifications of 101-0577

• Contents: SBC, Dev. Board, AC Adapter, Cable and Dynamic C® CD-ROM
• Product: Modules
• Data Bus Width: 10 bit
• Processor Type: Rabbit 3000
• Sram: 128 KB
• Flash: 256 KB
• Number Of I/os: 24
• Backup Battery: 3 V Lithium Coin Type
• Operating Voltage: 8 V to 40 V
• Power Consumption: 1 W
• Board Size: 100 mm x 100 mm x 29 mm
• Description/function: Computer Module
• Interface Type: Ethernet
• For Use With/related Products: BL2510
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

3.7 Other Hardware
3.7.1 Clock Doubler
The Coyote takes advantage of the Rabbit 3000 microprocessor’s internal clock doubler.
A built-in clock doubler allows half-frequency crystals to be used to reduce radiated
emissions. The 29.4 MHz frequency specified for the Coyote is generated using a
14.7456 MHz crystal. The clock doubler will not work for crystals with a frequency
above 26.7264 MHz.
The clock doubler may be disabled if 29.4 MHz clock speeds are not required. Disabling
the Rabbit 3000 microprocessor’s internal clock doubler will reduce power consumption
and further reduce radiated emissions. The clock doubler is disabled with a simple config-
uration macro as shown below.
34
1. Select the “Defines” tab from the Dynamic C
2. Add the line
3. Click
The clock doubler is enabled by default, and usually no entry is needed. If you need to
specify that the clock doubler is always enabled, add the line
always enable the clock doubler.
in the project file where you defined the macro.
NOTE: Disabling the clock doubler will degrade the A/D and D/A conversion.
OK
to save the macro. The clock doubler will now remain off whenever you are
CLOCK_DOUBLED=0
to always disable the clock doubler.
Options > Project Options
CLOCK_DOUBLED=1
Coyote (BL2500)
menu.
to