101-0679 Rabbit Semiconductor, 101-0679 Datasheet - Page 17

• Manufacturer Part Number: 101-0679
• Description: KIT DEV RABBIT RCM3600 INTL
• Manufacturer: Rabbit Semiconductor
• Series: RabbitCore 3000r
• Type: MPU Moduler

Specifications of 101-0679

• Contents: RabbitCore Module, Dev. Board, Cable and Dynamic C® CD-Rom
• Processor To Be Evaluated: Rabbit 3000
• Interface Type: RS-232
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Operating Supply Voltage: 5 V
• For Use With/related Products: RCM3600
• Lead Free Status / RoHS Status: Vendor undefined / Vendor undefined

2.3 Starting Dynamic C
Once the RCM3600 is connected as described in the preceding pages, start Dynamic C by
double-clicking on the Dynamic C icon or by double-clicking on dcrabXXXX.exe in
the Dynamic C root directory, where XXXX are version-specific characters. Dynamic C
uses the serial COM port on your PC that you specified during installation.
If you are using a USB port to connect your computer to the RCM3600 module, choose
Options > Project Options
2.4 Run a Sample Program
Use the
SAMPLES
window will open on your PC and will display a small square bouncing around in a box.
2.4.1 Troubleshooting
If a program compiles and loads, but then loses target communication before you can
begin debugging, it is possible that your PC cannot handle the default debugging baud
rate. Try lowering the debugging baud rate as follows.
• Locate the
If there are any other problems:
• Check that the RCM3600 is powered correctly — the power LED above the
• Check to make sure you are using the
• Check both ends of the programming cable to ensure that they are firmly plugged into
• Ensure that the RCM3600 module is firmly and correctly installed in its connectors on
• Select a different COM port within Dynamic C. From the
User’s Manual
Communications
button on the Prototyping Board should be lit.
programming cable.
the PC and the programming port on the RCM3600.
the Prototyping Board.
Project Options
then click OK. Press
still reports it is unable to locate the target system, repeat the above steps until you locate
the active COM port.
File
folder. Press function key
menu to open the sample program
Serial Options
, then select
menu. Choose a lower debug baud rate.
<Ctrl-Y>
and select “Use USB to Serial Converter.”
dialog in the Dynamic C
Communications
to force Dynamic C to recompile the BIOS. If Dynamic C
F9
to compile and run the program. The
PROG
PONG.C
connector, not the
. Select another COM port from the list,
Options > Project Options >
, which is in the Dynamic C
Options
DIAG
menu, select
connector, on the
STDIO
RESET
11