TOOLSTICK327DC Silicon Laboratories Inc, TOOLSTICK327DC Datasheet - Page 5
![DAUGHTER CARD TOOLSTCK C8051F327](/photos/9/25/92541/toolstick327dc_sml.jpg)
TOOLSTICK327DC
Manufacturer Part Number
TOOLSTICK327DC
Description
DAUGHTER CARD TOOLSTCK C8051F327
Manufacturer
Silicon Laboratories Inc
Series
ToolStickr
Type
MCUr
Datasheet
1.TOOLSTICK327DC.pdf
(16 pages)
Specifications of TOOLSTICK327DC
Contents
Board, Cable
Processor To Be Evaluated
C8051F327
Interface Type
USB
Operating Supply Voltage
2.7 V to 3.6 V
Lead Free Status / RoHS Status
Lead free / RoHS non-compliant
For Use With/related Products
C8051F327
For Use With
336-1345 - TOOLSTICK BASE ADAPTER336-1182 - ADAPTER USB DEBUG FOR C8051FXXX
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
336-1481
ToolStick-F327DC
5.4. Keil uVision2 and uVision3 Silicon Laboratories Drivers
As an alternative to the Silicon Laboratories IDE, the uVision debug driver allows the Keil uVision2 and uVision3
IDEs to communicate with Silicon Laboratories on-chip debug logic. In-system Flash memory programming
integrated into the driver allows for rapidly updating target code. The uVision2 and uVision3 IDEs can be used to
start and stop program execution, set breakpoints, check variables, inspect and modify memory contents, and
single-step through programs running on the actual target hardware.
For more information, please refer to the uVision driver documentation. The documentation and software are
available from the Downloads webpage (www.silabs.com/mcudownloads).
5.5. ToolStick Terminal
The ToolStick Terminal program provides the standard terminal interface to the target microcontroller's UART.
However, instead of requiring the usual RS-232 and COM port connection, ToolStick Terminal uses the USB
interface of the ToolStick Base Adapter to provide the same functionality.
In addition to the standard terminal functions (send file, receive file, change baud rate), two GPIO pins on the target
microcontroller can be controlled using the Terminal for either RTS/CTS handshaking or software-configurable
purposes (see the demo software for an example).
See Section "6.8. Using ToolStick Terminal‚" on page 12 for more information. The software is available on the
ToolStick webpage (www.silabs.com/toolstick).
Rev. 0.1
5