R0K521134S000BE Renesas Electronics America, R0K521134S000BE Datasheet - Page 11

• Manufacturer Part Number: R0K521134S000BE
• Description: KIT EVAL STARTER FOR R8C/13
• Manufacturer: Renesas Electronics America
• Series: Renesas Starter Kits (RSK)r
• Type: MCUr

Specifications of R0K521134S000BE

• Contents: CPU Board, LCD Display Module, E8 Emulator, Cable, QuickStart Guide and CD-ROM
• For Use With/related Products: R8C/13
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

5.2. Connecting the debugger
For this tutorial it is not necessary to provide an external power supply to the board. The power will be obtained from the USB port. Please
be aware that if you have too many devices connected to your USB port it may be shut down by windows. If this happens remove some
devices and try again. Alternatively provide an external power source taking care to ensure the correct polarity and voltage.
The Quick Start Guide provided with the RSK board gives detailed instructions on how to connect the E8 to the host computer. The
following assumes that the steps in the Quick Start Guide have been followed and the E8 drivers have been installed.
5.3. Connecting to the target with the E8
This section will take you through the process of connecting to the device, programming the Flash and executing the code.
•
•
•
•
•
•
•
•
•
•
•
Fit the LCD module to J8 on the RSK ensuring that pin 1 on the module corresponds to the indication on the RSK PCB.
Connect the E8 debugger to the USB port on your computer.
Connect the E8 Debugger to the target hardware ensuring that it is plugged into the connector marked J6/E8 which is
nearest the power connector.
If supplying external power to the board this can be turned on now.
Click the <Connect> button
on the debug toolbar
The “Emulator Setting” dialog will be shown.
Note: If this is the first time you have connected
with the current HEW project you will be shown
a “Wizard” version of this dialog, use the settings
as described here.
Select the correct device type (e.g. R5F21134
for RSKR8C13).
Select “Download emulator firmware”.
If the E8 is to provide power to the RSK board,
select “Power Target from E8” and choose the
“5.0V” option. Otherwise connect a 5V centre
positive supply and switch it on.
Select the “Firmware Location” tab.
Select the ‘SessionR8C_E8_System’ debug
session.
7