3DK2218 Renesas Electronics America, 3DK2218 Datasheet - Page 3

• Manufacturer Part Number: 3DK2218
• Description: DEV EVAL KIT H8S/2218
• Manufacturer: Renesas Electronics America
• Series: H8®r
• Type: MCUr

Specifications of 3DK2218

• Contents: 3-D Board, Jumper Link, Header Connectors and CD-ROM
• For Use With/related Products: H8S/2218
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Renesas Technology Europe Ltd.
7) Choose “Connect”, by clicking on the Connect button.
8) When prompted, select the target configuration file for the
9) If prompted to select the communication driver for HMon, click on
10) When prompted, select COM1, a Baud Rate of 38400 and click
11) HEW will attempt to connect to the embedded HMon. A
12) Select the “Download HMon using Boot Mode” radio button and
13) While trying to download HMon using Boot mode, the following
Click "Yes" to continue with the download.
FDT is now configured for use with the 3DK. Save the workspace.
H8S/2218U and click “OK”.
“serialdrv.dll” and click “OK”.
Do not select USBDrv.dll. This driver is for use with the FDM
only. The FDM is not supported by 3DK2218U.
“OK”.
connection dialogue box will then appear because embedded
HMon is not yet programmed into the 3DK.
click “OK”.
dialog will appear:
a.
b. Click on the Kernels for your 3DK. These are denoted by a
c.
d. Select USB Direct to connect to your 3DK, and click “Next”.
e.
f.
g. Configure the settings to Automatic Protection and Advanced
h. Click “Finish” to accept the settings.
i.
j.
k. Click the “Next” button.
l.
m. Select the Communications tab and verify that USB Direct is selected.
n. Click on the Device tab, and verify the device is set to H8S/2218UF. The
Select your device from the drop down menu.
.3DK after the version. If these are not listed, use the
“Browse” button to locate \Kernels\ProtB directory in FDT in
your program files directory. Navigate to your device and
then browse down to the device specific FDT configuration
file.
Click the “Next” button.
(This is because the BOOT Mode download is done using
USB connection.)
The CPU Crystal Frequency of the 3DK should be preset to
the default value, click “Next” to accept the settings.
Configure the settings to User Mode. Click “Next”.
Messaging.
FDT is now configured for use with the 3DK. By clicking on the wand, you may open the Flash Properties
window. The FDT settings may be inspected using the category Tabs.
Click on the Kernel tab, verify that the path is set to the Kernels for your 3DK and the device operating
frequency is set to 24MHz. The kernels are denoted by a .3DK after the version. If these parameters require
changing, double-click the path in the window to open the wizard and select the Kernels for your 3DK
Enter the Frequency for the 3DK as 24 and click “Finish”
Should these settings require alteration, double-click the required parameter,
make the required change and click “Finish” to close the wizard.
device selected is determined by the choice of kernels, previously selected.
.
.
D005316_11_v01
3