DEMOKIT-LG2 Renesas Electronics America, DEMOKIT-LG2 Datasheet - Page 50

• Manufacturer Part Number: DEMOKIT-LG2
• Description: KIT DEMO 78K0 LG2 UPD78F0397
• Manufacturer: Renesas Electronics America

Specifications of DEMOKIT-LG2

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

DemoKit-LG2 User’s Manual
44
Table 11. Device Setup Box: Standard Properties
•
Group/Item
Parameter file
PRM File
Read button
Host
connection
Supply
oscillator
Standard Properties: The Standard tab contains options for the parameter file, host
connection, supply oscillator, and operating mode. Refer to the user’s manual for the target
device when setting properties.
Option
—
—
Port list box
Speed list box
Frequency box
Multiply rate
Figure 48. Device Setup Box: Standard Tab
Description
Specifies the parameter file to be rewritten into the target MCU’s flash memory
Note: parameter file data must not be revised because it is related to the
guarantee of rewrite data. The checksum function protects the parameter file. If
the checksum result indicates an error, the FPL3 does not accept the file.
Opens a window for specifying a parameter file is displayed. Specify a desired
file then click Open
Selects a channel from COM1 to COM256 for communication between the
DemoKit-LG2 board and host computer
Ports also can be selected using the Device Manager, as explained in Section
5.3, “Confirmation of USB Driver Installation.”
Selects a communication rate for the selected communication channel:
• 9600 bps
• 19200 bps
• 38400 bps
• 115200 bps
For selectable communication rates, refer to the MCU user's manual.
Sets the clock frequency of the target system; operating frequency varies by
device, so always check device specifications before setting the frequency
Specifies the division rate or multiplication rate of the target device. If the
target device has an on-chip PLL circuit, enter a division rate or multiplication
rate according to the user environment. The selectable division rate or
multiplication rate differs depending on the device
Before making a selection, check the specifications of the device used. If the
target device does not have an on-chip PLL circuit, select "1.0". On the initial
screen, the default setting is displayed according to the parameter file.