EPSILON5-A1 Equinox Technologies, EPSILON5-A1 Datasheet - Page 38

• Manufacturer Part Number: EPSILON5-A1
• Description: ISP PORTABLE PROGRAMMER USB
• Manufacturer: Equinox Technologies
• Series: Epsilon5r
• Type: Portable ISPr

Specifications of EPSILON5-A1

• Contents: Programmer, Software, Cables and Documentation
• Ic Product Type: In-Circuit Programmer
• Features: 2Mbits Of On-Board Non-Volatile FLASH Memory For User Project Storage
• Interface Type: JTAG
• Mcu Supported Families: ATmega And AT91SAM7
• Mpu Supported Families: AVR
• Rohs Compliant: Yes
• External Depth: 31mm
• Height: 189mm
• Length: 80mm
• For Use With/related Products: ATMEL AT89S, AVR, AT91SAM7, NXP P89C51Rx2 P89C66x, Zensys, Serial EEPROM's
• Other names: 483-1000

2.5 Development Mode (EDS)
2.5.1 Overview
In ‘Development Mode’, the programmer is controlled from the EQTools – EDS (Equinox
Development Suite) running on a PC. The Development utility is called Equinox Development Suite or
EDS for short. In this mode it is NOT necessary to upload the ‘Programming Project’ to the
programmer as the EDS utility co-ordinates all programming operations.
In EDS Mode, you can perform the following actions under PC control:
2.5.2 Creating a new EDS (Development Mode) Project
To test a Target Chip in EDS (Development Mode), follow the instructions detailed below:
EPSILON5 MKII Programmer - User Guide V1.10 – 10th July 2006
The EDS Wizard will now launch
•
•
•
•
•
•
•
•
•
Write data directly to a Target Device from the PC e.g. a HEX file
Read data from a Target Device to a file on the PC
Write / Read the Configuration Fuses of a Target Device
Write / Read the Security Fuses of a Target Device
Read the Target Vcc Voltage
Launch EQTools
From the Welcome Screen, select the ‘Create a new Equinox Development Project (EDS)’
option.
OR
From the left-hand pane, select the <Development> tab and then select ‘New Development
Project’.
Follow the EDS Wizard by filling in each tab and then clicking the <Next> button:
•
•
•
•
•
•
•
Select Programmer – click <Get Info> button to detect your attached programmer
Select Project Type – leave as the default ‘Standalone Keypad Operation’
Select Device – This is your Target Chip.
Select Target Oscillator – If unsure of settings leave all settings as the defaults and click
<Next>.
Select Target Voltage
Select FLASH Data File (optional – you can enter the file name at a later stage in EDS)
Select EEPROM Data File (optional – you can enter the file name at a later stage in EDS)
27