HS2214EPI62H Renesas Electronics America, HS2214EPI62H Datasheet - Page 204

• Manufacturer Part Number: HS2214EPI62H
• Description: EMULATOR BASE UNIT H8S/2214
• Manufacturer: Renesas Electronics America
• Type: Microcontrollerr

Specifications of HS2214EPI62H

• Contents: E6000 Emulator and CD-ROM
• For Use With/related Products: H8S/2214
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

[General] page (cont)
The MCUs selectable by the [Device] option and options that depend on the MCUs are listed below. To emulate
an MCU with a description in the Expansion Hardware column, connect the correct expansion hardware.
[Break on access error]
[Enable internal ROM area write]
[User VCC Threshold]
[User Signals]
[Driver]
[Change driver in start up]
182
When this box is checked, a break (the user program stops) occurs if
your program accesses an access-prohibited area or writes to a write-
protected area.
When this box is checked, writing to the internal ROM area is enabled.
For the result of writing, see the [Status] window.
Sets the voltage level for the user system. [Down] will be displayed in
[User System Voltage] of the [Extended Monitor] window when the actual
user VCC of the target system is lower than the specified value.
When this box is checked, the reset, NMI, and bus request signals from
the user system are enabled. Note that the standby signal is always
invalid because the hardware standby function is not supported.
However, the status of the signal can be checked in the [Extended
Monitor] window.
Displays the E6000 driver that is currently installed.
When this box is checked, selection of a driver will be available next time
the emulator is connected.