MCB2100+U NXP Semiconductors, MCB2100+U Datasheet - Page 9

• Manufacturer Part Number: MCB2100+U
• Description: BOARD EVAL/ULINK JTAG LPC210XARM
• Manufacturer: NXP Semiconductors
• Series: Keilr
• Type: ARM7 Processor, Microcontrollerr

Specifications of MCB2100+U

• Contents: Evaluation Board, ULINK JTAG, Debugger and Software
• For Use With/related Products: LPC2114,2119,2124,2129,2194
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: 568-1755; OM10046

NXP Semiconductors
4. Hardware
AN10302_4
Application note
Fig 6. Keil MCB2100 evaluation board overview.
4.1 Keil MCB2100 evaluation board
Figure 6
JTAG port — Connection to JTAG emulator (e.g. Keil ULink). This is a standard JTAG
port as outlined in ARM documentation.
ETM (Embedded Trace Macrocell) port — Provides interface to emulators with trace
capability.
P3 and P4, CAN ports — These provide access to the CAN ports (On boards that
feature a microcontroller with CAN interfaces).
P1 and P2, UARTs — Access to UART0 and UART1.
S1 reset — Microcontroller reset.
S2 ISP/INT1 — This button pulls the P0.14 pin of the microcontroller LOW, providing
either an external interrupt or manual entry into ISP mode.
shows an overview of the Keil MCB2100 evaluation board.
Rev. 04 — 12 October 2006
Using the Philips LPC2000 Flash utility
AN10302
© NXP B.V. 2006. All rights reserved.
9 of 14