FS-9062 Digi International, FS-9062 Datasheet - Page 14

• Manufacturer Part Number: FS-9062
• Description: JTAG_BOOSTER FOR ANALOG DEVICES
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-9062

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: ADI, ADSP-BF531, 532, 533, 561
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

JTAG-Booster for Analog Devices Blackfin
1.7.
Trouble Shooting
Avoid long distances between your Host-PC and the target. If you are using
standard parallel extension cable, the JTAG-BOOSTER may not work. Don't use
Dongles between the parallel port and the JTAG-BOOSTER.
Switch off all special modes of your printer port (EPP, ECP, ...) in the BIOS
setup. Only standard parallel port (SPP) mode is allowed.
If there are problems with autodetection of the flash devices use the /DEVICE=
option. To speed up autodetection specify one of the options /8BIT /16BIT or
/32BIT.
Don't use hardware protected flash memories.
The used chip selects must be defined as output and inactive in the initialization
file (see chapter 1.9 “Initialization file JTBFxxx.INI”). Also the address bits must
be defined as output.
Use the option /NOWRSETUP to speed up flash programming.
If you have problems using the option /CFI (Common Flash Interface) use the
option
/CFIDEBUG
instead and redirect the program's output into a file.
Sending us this file helps in analyzing problems.
14
JTAG_ADSP-BLACKFINa.doc