ST92F150-EPB/US STMicroelectronics, ST92F150-EPB/US Datasheet - Page 17

• Manufacturer Part Number: ST92F150-EPB/US
• Description: BOARD PROGRAM FOR ST92F150 MCU
• Manufacturer: STMicroelectronics

Specifications of ST92F150-EPB/US

• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: 497-3100

ST9 EPB User Manual
APPENDIX A: USER AND WORK ENVIRONMENT PRECAUTIONS
The following precautions are recommended when using the programming board:
•
•
•
•
•
•
•
•
Any tester, equipment, or tool used at any production step or for any
manipulation of semi-conductor devices should have its shield connected to
ground.
Your programming board should be placed on a conductive table top, made of
steel or clean aluminum or covered by an antistatic surface (superficial
resistivity equal to or higher than 0.5 M /cm
cable (conductive cable from protected equipment to ground isolated through a
1 M
All manipulation of finished goods should be made at such a grounded
worktable.
The worktable should be free of all non-antistatic plastic objects.
An antistatic floor covering grounded through a conductive ground cable (with
serial resistor between 0.9 and 1.5 M ) should be used.
It is recommended that you wear an antistatic wrist or ankle strap, connected to
the antistatic floor covering or to the grounded equipment.
If no antistatic wrist or ankle strap is worn, before each manipulation of the
powered-on programming board, you should touch the surface of the grounded
worktable.
It is recommended that antistatic gloves or finger coats be worn.
It is recommended that nylon clothing be avoided while performing any
manipulation of parts.
resistor placed in series).
Appendix A: User and Work Environment Precautions
2
), grounded through a ground
17/24