EDK2215 Renesas Electronics America, EDK2215 Datasheet - Page 4

• Manufacturer Part Number: EDK2215
• Description: DEV EVALUATION KIT H8S/2215
• Manufacturer: Renesas Electronics America
• Series: H8®r
• Type: Microcontrollerr

Specifications of EDK2215

• Contents: 2G (Second-generation) Evaluation Board, HEW debugger support, Cable and CD-ROM
• For Use With/related Products: H8S/2215
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

The following procedure explains how to connect to the EDK2215 and debug the project in HEW.
Disconnect power from the board.
Move the User Program Mode jumper, marked UPM in CJ4 on the silkscreen on the board, to position (4 – 5), as shown.
The EDK uses HMON to connect to HEW and debugging is carried out in User Programming Mode. Re-apply power to the
EDK.
To run the program:
Congratulations! You have installed the software; programmed the EDK and run your first program with the debugger. To
continue learning about the tools and the board please read the supporting User Manuals
Technical Support
The EDK is a tool for evaluation purposes only. Technical support is limited to that which is provided on the Hitachi Micro
Systems website at:
Hitachi Micro Systems
4
•
•
•
•
•
•
•
•
•
•
The Program Counter will go to the program start address, denoted by a yellow arrow.
•
•
Running the Debugger
CJ4 (User Configuration)
CJ5 (Mode Configuration)
Click on the HMON FLASH Download Setting button.
Click on the USER radio button.
Ensure that the “uKernel Address” is set to H’1000, and that the “Referenced Value” box is not checked. Ensure
that the “Return Address” is set to H’0, and that the “Referenced Value” box is checked, and click “OK”
Click “Save Session”, from the “File” menu.
Click “Build”, “Debug”, “Connect”.
The console window will report that the EDK has connected.
Right click on the “.abs” file in the “Download Module” section, and choose “Download Module”.
Double-click on the resetprg.c file in the HEW Project workspace window, under the “C Source File” folder.
The C code listing will appear with a margin at the left showing the areas in memory where the code has been
loaded.
Click on the “ResetCPU” button,
Select the "Debug", "Reset Go" menu item.
A User LED on the EDK will start flashing,
http://www.hmse.com/products/edk/support/index.htm
PIN CONNECTIONS
2 – 3
2 – 3
.
4 – 5
4 – 5
7 - 8
7 – 8
10-11
11 – 12
Hitachi Micro Systems
D - Type
9 - Way
Switch
Reset
BOOT
Switch
CJ4
CJ5
D003786_11_v01
4