HS2378KCI01H Renesas Electronics America, HS2378KCI01H Datasheet - Page 168

• Manufacturer Part Number: HS2378KCI01H
• Description: ON CHIP DEBUG EMULATOR
• Manufacturer: Renesas Electronics America

Specifications of HS2378KCI01H

• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

20. Number of Software Breakpoint and [Stop At] Settings in the [Run...] Menu
21. Note on RUN-TIME Display
22. Note on Displaying COMMUNICATION TIMEOUT ERROR
23. Note on Downloading Program
24. Support of Double Float Format
25. Note on Continuous Step Execution
26. Note on Using the [Run program] Dialog Box
27. Note on Transition to Low-Power Consumption Mode
144
The maximum number of software breakpoints and [Stop At] settings allowed in the [Run...]
menu is 255. Therefore, when 255 software breakpoints are set, specification by [Stop At] in
the [Run...] menu becomes invalid. Use the software breakpoints and [Stop At] in the [Run...]
menu with 255 or less total settings.
The execution time of the user program displayed in the [Status] window is not a correct value
since the timer in the host computer has been used.
If COMMUNICATION TIMEOUT ERROR is displayed, the emulator cannot communicate
with the MCU. Select [Initialize] from the [File] menu to initialize the emulator.
In the [Load Program] dialog box, which is opened when [Load Program…] is selected, the
verify function is invalid. After downloading the program, perform verify in the [Verify S-
Record File with Memory] dialog box, which is opened when [Verify] is selected from the
[Memory] menu.
In the following memory operations, the double float format is not supported:
When the step is continuously executed by selecting [Step...] from the [Run] menu, do not use
the software breakpoint because this will cause the HDI to abnormally operate.
When [Run...] is selected from the [Run] menu to specify the stop address, there is the
following note:
The hardware standby function must not be used. If it is not used, the emulator will not operate
normally.
[Fill Memory] dialog box
[Search Memory] dialog box
MEMORY_FILL command
The [Format] specification in the [Copy Memory] dialog box is ignored. Memory is
copied in a byte unit.
When the breakpoint that has been set as Disable is specified as the stop address, note that
the breakpoint becomes Enable when the user program stops.