HS7727KCI01H Renesas Electronics America, HS7727KCI01H Datasheet - Page 5

no-image

HS7727KCI01H

Manufacturer Part Number
HS7727KCI01H
Description
ON CHIP DEBUG EMULATOR
Manufacturer
Renesas Electronics America
Datasheets

Specifications of HS7727KCI01H

Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
To connect the E10A emulator (hereinafter referred to as the emulator), the H-UDI port connector
must be installed on the user system to connect the user system interface cable. When designing
the user system, refer to the recommended circuit between the H-UDI port connector and the
MCU. In addition, read the E10A emulator user's manual and hardware manual for the related
MCU.
Table 1.1 shows the type number of the E10A emulator, the corresponding connector type, and
the use of AUD function.
Table 1.1 Type Number, AUD Function, and Connector Type
Type Number
HS7727KCM02H, HS7727KCI02H
HS7727KCM01H, HS7727KCI01H
The H-UDI port connector has the 36-pin and 14-pin types as described below. Use them
according to the purpose of the usage.
1. 36-pin type (with AUD function)
2. 14-pin type (without AUD function)
1. Connecting the E10A Emulator with the User System
The AUD trace function is supported. A large amount of trace information can be acquired in
realtime.
The AUD trace function cannot be used because only the H-UDI function is supported. For
tracing, only the internal trace function is supported. Since the 14-pin type connector is
smaller than the 36-pin type (1/2.5), the area where the connector is installed on the user
system can be reduced.
Connector
36-pin connector
14-pin connector
AUD Function
Available
Not available
1

Related parts for HS7727KCI01H