HS7727KCM02H Renesas Electronics America, HS7727KCM02H Datasheet - Page 224

• Manufacturer Part Number: HS7727KCM02H
• Description: ON CHIP DEBUG EMULATOR W/TRACE
• Manufacturer: Renesas Electronics America

Specifications of HS7727KCM02H

• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

6.5.8
1. When [Go to cursor], [Step In], [Step Over], or [Step Out] is selected, the settings of Break
2. Executing the instructions at the addresses containing BREAKPOINT invalidates the channel
3. If a PC break address condition is set to the slot instruction after a delayed branch instruction,
4. When a Break Condition is satisfied, emulation may stop after two or more instructions have
6.5.9
In the [Configuration] window, if [User] is set while the UBC_MODE command has been set, the
STEP-type commands that use BREAK_CONDITION2 for implementation cannot be used. If
these commands are used, the message box shown in figure 6.10 is displayed.
Note: Note the followings when the UBC is used in the user program:
204
Condition 2 are disabled.
2 settings of the BREAKCONDITION_SET command. Make sure not to set BREAKPOINTs
at addresses where the channel 2 settings of the BREAKCONDITION_SET command are to
be satisfied.
user program execution cannot be terminated before the slot instruction execution even when
the PC option is specified in the <addrcycle> parameter; execution stops before the branch
destination instruction.
been executed.
Notes on Setting the BREAKCONDITION_SET Command
Notes on Setting the UBC_MODE Command
When the E10A emulator is connected:
When the ASEMD0 pin is low without connecting the E10A emulator:
When the ASEMD0 pin is high without connecting the E10A emulator:
Always write 1 to bit 2 in the BRCR register.
Always write 1 to bit 2 in the BRCR register.
Always write 0 to bit 2 in the BRCR register.
Figure 6.10 [HDI] Message Box