R0K3306NKS000BE Renesas Electronics America, R0K3306NKS000BE Datasheet - Page 12

• Manufacturer Part Number: R0K3306NKS000BE
• Description: KIT DEV RSK RSK-M16C/6NK
• Manufacturer: Renesas Electronics America
• Series: Renesas Starter Kits (RSK)r
• Type: Microcontrollerr

Specifications of R0K3306NKS000BE

• Contents: CPU Board, LCD Display Module, E8 Emulator, Cable, QuickStart Guide and CD-ROM
• Architecture: 8/16-bit
• For Use With/related Products: M16C/6NK
• Lead Free Status / RoHS Status: Not applicable / Not applicable

6.4. Serial port
The microcontroller programming serial port 1 is connected to the RS232 connector. A serial port can be used by moving option resistors
and fitting the D connector. This can be connected to serial channel 1 if the E8a is disabled from using channel 1; or serial channel 0 while
the E8a is enabled.
If a serial port is used the D-connector U3 must be fitted and the RS232 transceiver enabled.
An additional serial port is connected to the application headers.
6.5. LCD Module
An LCD module is supplied to be connected to the connector J11. This should be fitted so that the LCD module lies over J3. Care should be
taken to ensure the pins are inserted correctly into J11.The LCD module uses a 4 bit interface to reduce the pin allocation. No contrast
control is provided; this is set by a resistor on the supplied display module. The module supplied with the RSK only supports 5V operation.
Table 6-5 shows the pin allocation and signal names used on this connector.
Description
TxD1
RxD1
CLK1
RS232
Transceiver
Enable
Description
Programming
Serial Port
Programming
Serial Port
Programming
Serial Port
Disables/Enables
U3 RS232
Transceiver
Function
Function
R13
R12
R14
Fit For E8a
Fit For RS233
R42
Enable
Table 6-3: Serial port connections
Table 6-4: RS232 enable
R68
R44
NA
Remove for
E8a
R39
RS233 Enable
Remove for
8
R69
R47
NA
Channel 0
RS232
Fit for
R39
Fit For RS233
Disable
R68
R44
NA
Remove for
Channel 0
RS232
R42
Remove for RS233 Disable
R68
R44
NA
Channel 1
RS232
Fit for
R69, R13
R47, R12
R14
Remove for
Channel 1
RS232