FS-9003 Digi International, FS-9003 Datasheet - Page 24

• Manufacturer Part Number: FS-9003
• Description: JTAG-BOOSTER FOR XSCALE 3.3V
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-9003

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: Intel XScale, 3.3V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

JTAG-Booster for Intel XScale
Target no longer connected
There is a cyclic check of the JTAG chain. Check target power. Check target
connection.
There are unknown parts in the JTAG chain. Please use the option
/IROFFS= to specify the instr. reg. offset of the CPU.
If there are unknown parts in the JTAG chain, the program isn’t able to
determine the logical position of the CPU’s instruction register.
There is no Intel XScale in the JTAG chain
No Intel XScale was found in the JTAG chain. Check the target power. Try
with option /DRIVER=4 again.
Value of option /FILE-OFFSET out of range
The value of the option /FILE-OFFSET= points behind end of file.
wrong driver #
The value specified with the option /DRIVER= is out of range.
Wrong Flash Identifier (xxxx)
No valid identifier found. Check the specified chip select signal and the bus
width. Try with the option /DEVICE= .
Wrong length of boundary scan register. Should be 385 for a Intel
PXA210/250. (Should be 410 for a Intel PXA255/26x/Should be 356 for a
Intel IOP321/ Should be 498 for a Intel IXP425.)
The length of the boundary scan register of the selected part (if there are
more than one in the chain) does not fit to the Intel XScale. Check the target
connection. Check the target CPU type. Check the settings for /IROFFS=
and /CPUPOS= , if there are several parts in the JTAG chain.
24
JTAG_XScaleb.doc