FS-9019 Digi International, FS-9019 Datasheet - Page 24

• Manufacturer Part Number: FS-9019
• Description: JTAG-BOOSTER FOR ALCHEMY 3.3V
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-9019

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: AMD Alchemy, 3.3V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

AMD Alchemy Solutions Processors
•
•
•
•
•
•
•
24
Target no longer connected
There is a cyclic check of the JTAG chain. Check target power. Check target
connection.
There are unknown parts in the JTAG chain. Please use the option
/IROFFS= to specify the instr. reg. offset of the CPU.
If there are unknown parts in the JTAG chain, the program isn’t able to
determine the logical position of the CPU’s instruction register.
There is no AMD Alchemy Solutions Processors in the JTAG chain
No AMD Alchemy Solutions Processors was found in the JTAG chain. Check
the target power. Try with option /DRIVER=4 again.
Value of option /FILE-OFFSET out of range
The value of the option /FILE-OFFSET= points behind end of file.
wrong driver #
The value specified with the option /DRIVER= is out of range.
Wrong Flash Identifier (xxxx)
No valid identifier found. Check the specified chip select signal and the bus
width. Try with the option /DEVICE= . Use the option /8BIT or /16BIT or
/32BIT to specify the correct data bus size.
Wrong length of boundary scan register. Should be 569 for a AMD
Alchemy Solutions Au1000 Processor. (Should be 672 for a AMD
Alchemy Solutions Au1100 Processor. Should be 744 for a AMD
Alchemy Solutions Au1500 Processor Should be 773 for a AMD
Alchemy Solutions Au1550 Processor.)
The length of the boundary scan register of the selected part (if there are
more than one in the chain) does not fit to the AMD Alchemy Solutions
Processors. Check the target connection. Check the target CPU type. Check
the settings for /IROFFS= and /CPUPOS= , if there are several parts in the
JTAG chain.
JTAG_alchemyb.doc