FS-9019 Digi International, FS-9019 Datasheet - Page 75

• Manufacturer Part Number: FS-9019
• Description: JTAG-BOOSTER FOR ALCHEMY 3.3V
• Manufacturer: Digi International
• Series: Digi/FS Forthr
• Type: FLASHr

Specifications of FS-9019

• Contents: Programmer and Associated Interface Software
• For Use With/related Products: AMD Alchemy, 3.3V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

/DEVICE-BASE=hhhhhh
This option specifies an I²C device starting address. The default values are
chosen to access a serial EEPROM. By changing the device starting address
different devices can be selected. As SPI/MicroWire devices are selected by the
chip select signal instead of an address, this option does not make sense for
SPI/MicroWire devices.
Default:
Default:
Default:
/OFFSET=hhhhhh
The programming starts at an offset of hhhhhh relative to the start address of the
serial device.
Default:
Abbreviation:
/FILE-OFFSET=hhhhhh
If FILE-OFFSET is specified, the first hhhhhh bytes of the file are skipped and
not programmed to target.
Default:
Abbreviation:
/LENGTH=hhhhhh
The number of programmed bytes may be limited to LENGTH. If no LENGTH is
specified the whole file is programmed.
Abbreviation:
/NODUMP
In case of a verify error the contents of the I²C-Device is written to a file with the
extension .DMP. With option /NODUMP you can suppress this feature.
/SERCS=pin_name (SPI/MicroWire mode only)
Specifies the CPU pin used to select the serial device.
In SPI mode SERCS is treated as low active.
In MicroWire mode SERCS is treated as high active.
/SERCLK=pin_name
Specifies the CPU pin used for serial clock output.
JTAG_alchemyb.doc
/DEVICE-BASE=5000
/DEVICE-BASE=500000
/DEVICE-BASE=0
/OFFSET=0
/O=
/FILE-OFFSET=0
/FO=
/L=
AMD Alchemy Solutions Processors
(if option /SERBIG omitted)
(if option /SERBIG specified)
(for SPI/MicroWire devices)
75