P7S-14P Omron, P7S-14P Datasheet - Page 19

• Manufacturer Part Number: P7S-14P
• Description: SOCKET PC MNT FOR G7S RELAY
• Manufacturer: Omron
• Series: G7Sr
• Type: Socketr

Specifications of P7S-14P

• Mounting Type: Through Hole
• Number Of Positions: 14
• Termination Style: PC Pin
• Current Rating: 6A
• Terminal Type: Through Hole
• No. Of Pins: 14
• Svhc: No SVHC (15-Dec-2010)
• Accessory Type: Socket
• External Depth: 47mm
• External Length / Height: 80.5mm
• External: RoHS Compliant
• Associated Relay Series: G7S
• Mounting Style: Through Hole
• Width: 23 mm
• Socket Mounting: Through Hole
• Socket Terminals: Quick Connect
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: G7S Series
• For Use With: Z2362 - RELAY SAFETY 6A 24VDC PLUG-INZ2363 - RELAY SAFETY 6A 24VDC PLUG-IN
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: P7S14P; Z2418

Process 5
Process 6
Process 7
Cleaning
Cooling
Coating
http://www.ia.omron.com/
1. Upon completion of automatic soldering, use a
2. Fully sealed Relays are washable. Do not,
Refer to the following table to select the cleaning
method and solvent.
Cleaning Method
1. With the G7S or G7SA, coating will penetrate
2. Be very careful in selecting the coating material.
Neither boiling cleaning nor immersion cleaning is
possible.
Clean only the back of the PCB with a brush.
fan or other device to forcibly cool the PCB. This
helps prevent the Relay and other components
from deteriorating from the residual heat of
soldering.
however, put fully sealed Relays in a cold cleaning
solvent immediately after soldering or the seals
may be damaged.
inside Relays and damage the contacts.
Therefore either do not apply coating at all or
apply the coating first, before mounting the
Relays.
Depending on the type of coating selected, it may
damage the Relay case and chemically dissolve
the seals, causing them to lose their sealing
capability.
G7S
G7SA
(c)Copyright OMRON Corporation 2007 All Rights Reserved.
Cooling
3. Do not secure the entire Relay in resin, or the
Required
Relay's characteristics will be changed.
Do not exceed the maximum value for the
coating's ambient operating temperature.
G7SA
C-14