58552-1 Tyco Electronics, 58552-1 Datasheet

no-image

58552-1

Manufacturer Part Number
58552-1
Description
DIE SET F/OPTIC FSMA USE W/A9996
Manufacturer
Tyco Electronics
Series
Pro-Crimper™ IIIr
Type
Hand Toolr
Datasheet
1.58552-1.pdf (3 pages)

Specifications of 58552-1

Connector Type
Fiber Optic, FSMA and ST
Crimp Handle
A9996-ND
Crimp Or Cable Size
3.0mm Dia
Lead Free Status / RoHS Status
Not applicable / Not applicable
Other names
A20218
PROPER USE GUIDELINES
1. INTRODUCTION
This instruction sheet provides application and
maintenance procedures for PRO–CRIMPER III Hand
Tool Assembly 58551–1 and Crimping Die Assembly
58552–1. See Figure 1. The hand tool consists of the
die assembly and PRO–CRIMPER III Hand Tool
Frame Assembly 58532–1, and crimps STC Fiber
Optic Connectors. The die assembly can be
purchased separately, or purchased with the hand
tool.
The information on connector part numbers and
connector assembly procedures, refer to the
appropriate instruction sheet packaged with the
connector.
Refer to Instruction Sheet 408–4020 for information
concerning the use and maintenance of Hand Tool
Frame Assembly 58532–1. Read these and all
referenced materials before using the die assemblies.
E
NOTE
i
All dimensions in this document are in millimeters
[with inches in brackets]. Figures and Illustrations
are for reference only and are not drawn to scale.
Crimping Die
Assembly 58552-1
PRO-CRIMPER* III Hand
Tool Assembly 58551-1
and Die Assembly 58552-1
Figure 1
Reasons for reissue are provided in Section 7,
REVISION SUMMARY.
2. DESCRIPTION
The die assembly features an anvil die and a crimper
die. When closed, the dies produce four crimping
chambers that crimp the ferrule of the connector onto
the fiber–optic cable. Each die is held in the tool jaws
with a single die–retaining screw. See Figure 2.
3. DIE INSTALLATION
1. Close the tool handles until the ratchet releases;
then allow the tool handles to open FULLY.
2. Install anvil die in the moving jaw of the hand
tool. Align the die with the retaining screw hole;
then secure die with the button head cap screw. Do
NOT fully tighten.
3. Install crimper die in the stationary jaw of the
hand tool. Slowly close the tool handles, allowing
the die to align itself with the upper die. When dies
are properly aligned, securely tighten both screws.
PRO-CRIMPER III
Frame Assembly
58532-1
www.tycoelectronics.com
408-4090
1

58552-1 Summary of contents

Page 1

... Hand Tool Frame Assembly 58532–1. Read these and all referenced materials before using the die assemblies. E PRO-CRIMPER* III Hand Tool Assembly 58551-1 and Die Assembly 58552-1 PRO-CRIMPER III Frame Assembly 58532-1 Figure 1 Reasons for reissue are provided in Section 7, REVISION SUMMARY ...

Page 2

... Figure 5 provides information on die openings. Tyco Electronics Corporation 408-4090 Die Retaining Screws Ratchet A ...

Page 3

... REPLACEMENT PRO–CRIMPER III Hand Tool Assembly 58551–1 and Die Assembly 58552–1 are inspected before shipment. Tyco Electronics recommends that the dies be inspected immediately upon arrival at your facility to ensure that the dies have not been damaged during shipment ...