58552-1 Tyco Electronics, 58552-1 Datasheet - Page 3

• Manufacturer Part Number: 58552-1
• Description: DIE SET F/OPTIC FSMA USE W/A9996
• Manufacturer: Tyco Electronics
• Series: Pro-Crimper™ IIIr
• Type: Hand Toolr

Specifications of 58552-1

• Connector Type: Fiber Optic, FSMA and ST
• Crimp Handle: A9996-ND
• Crimp Or Cable Size: 3.0mm Dia
• Lead Free Status / RoHS Status: Not applicable / Not applicable
• Other names: A20218

5.4. Ratchet Adjustment
The tool frame assembly ratchet mechanism features
an adjustment wheel with eight settings. If the crimp
is not acceptable, adjust the ratchet as follows:
Rev
PRO-CRIMPER III Hand Tool Assembly 58551-1
1. Remove the lockscrew from the ratchet
adjustment wheel.
2. With a screwdriver, adjust the ratchet wheel
from the opposite side of the tool.
3. Observe the ratchet adjustment wheel. If a
tighter crimp is required, rotate the adjustment
wheel COUNTERCLOCKWISE to a
A
Ratchet
Adjustment
Wheel
3.84 +0.10
[.151 +.004]
Lockscrew (Typ)
3.25 +0.10
[.128 +.004]
Screwdriver
Figure 4
(Figure 4)
Tyco Electronics Corporation
Figure 5
6. REPLACEMENT
PRO–CRIMPER III Hand Tool Assembly 58551–1
and Die Assembly 58552–1 are inspected before
shipment. Tyco Electronics recommends that the dies
be inspected immediately upon arrival at your facility
to ensure that the dies have not been damaged
during shipment.
Order replacements through your Tyco Electronics
Representative, or call 1–800–526–5142, or send a
facsimile of your purchase order to 1–717–986–7605,
or write to:
7. REVISION SUMMARY
higher–numbered setting. If a looser crimp is
required, rotate the adjustment wheel
CLOCKWISE to a lower–numbered setting.
4. Replace the lockscrew.
5. Make a sample crimp and measure the crimp
height. If the crimp is acceptable, replace and
secure the lockscrew. If the dimension is
unacceptable, continue to adjust the ratchet, and
again measure a sample crimp.
CUSTOMER SERVICE (38–35)
TYCO ELECTRONICS CORPORATION
P.O. BOX 3608
HARRISBURG, PA 17105–3608
4.37 +0.10
[.172 +.004]
S Updated document to corporate requirements
S New format
5.18 +0.10
[.204 +.004]
10.16 [.400]
Ref
408-4090
3
of 3