58605-2 Tyco Electronics, 58605-2 Datasheet

Page 1

... PRO–CRIMPER III Hand Crimping Tool Assembly 58605–1 consists of Die Assembly 58605–2 and PRO–CRIMPER III Hand Crimping Tool Frame 354940–1. The die assembly consists of crimping dies and a locator assembly. Read these instructions thoroughly before crimping any contacts. ...

Page 2

... PRO-CRIMPER III Hand Crimping Tool Assembly 58605-1 Nut Chamfer Wire Crimper Offset Wire Anvil Insulation Anvil 2. DESCRIPTION (Figures 1 and 2) The tool features a tool frame with a stationary jaw and handle, a moving jaw, a moving handle, and an adjustable ratchet that ensures full contact crimping. ...

Page 3

... PRO-CRIMPER III Hand Crimping Tool Assembly 58605-1 4. CONTACT SUPPORT ADJUSTMENT NOTE The contact support is preset prior to shipment, but minor adjustment may be necessary Make a sample crimp and determine if the contact is straight, bending upward, or bending downward adjustment is required, loosen the screw that holds the contact support onto the locator assembly ...

Page 4

Position the contact so that the mating end of the contact is on the locator side of the tool, and so that the open “U” of the wire and insulation barrels must face the top of the tool. Place ...

Page 5

... PRO-CRIMPER III Hand Crimping Tool Assembly 58605-1 8. MAINTENANCE Ensure that the tool and dies are clean by wiping them with a clean, soft cloth. Remove any debris with a clean, soft brush. Do not use objects that could damage the tool. When not in use, keep handles closed to prevent objects from becoming lodged in the crimping dies, and store in a clean, dry area ...