58605-2 Tyco Electronics, 58605-2 Datasheet - Page 3

• Manufacturer Part Number: 58605-2
• Description: PROCRIMP DIE JPT W/SEAL
• Manufacturer: Tyco Electronics
• Series: Pro-Crimper™ IIIr

Specifications of 58605-2

• Connector Type: Crimp Terminals
• Crimp Handle: Tyco/AMP 58605-1
• Crimp Or Cable Size: 1.0-2.5mm²
• Lead Free Status / RoHS Status: Lead free by exemption / RoHS compliant by exemption
• Other names: Q3911050

4. CONTACT SUPPORT ADJUSTMENT
Rev
Adjustment
Screw for
Contact
Support
PRO-CRIMPER III Hand Crimping Tool Assembly 58605-1
NOTE
1. Make a sample crimp and determine if the
contact is straight, bending upward, or bending
downward.
2. If adjustment is required, loosen the screw that
holds the contact support onto the locator
assembly.
NOTE
3. Place a contact with wire into the proper nest
and close the tool handles until the ratchet reaches
the sixth click, or until the contact support touches
the contact.
4. Slightly loosen the nut that holds the locator
assembly onto the tool frame.
5. Move the contact support as required to
eliminate the bending of the contact.
6. Tighten the nut and close the handles until the
ratchet releases.
A
i
i
Contact
Support
The contact support is preset prior to shipment,
but minor adjustment may be necessary.
The ratchet has detents that create audible clicks
as the tool handles are closed.
Locator
(Figure 3)
Tyco Electronics Corporation
Wire
Seal
Back of Tool
(Wire Side)
Figure 3
5. CRIMPING PROCEDURE
Refer to the table in Figure 1 and select wire of the
specified size and insulation diameter. Strip the wire
to the length indicated in Figure 1, taking care not to
nick or cut wire strands. Select an applicable contact
and identify the appropriate crimp section according
to the wire size markings on the tool. Refer to
Figure 3 and proceed as follows:
Wire
7. Remove and inspect the contact.
8. Make another sample crimp. If the contact is
straight, tighten the contact support screw. If the
contact is still being bent during crimping, repeat
the adjustment procedure.
NOTE
1. Hold the tool so that the back (wire side) is
facing you. Squeeze tool handles together and
allow them to open fully.
2. Holding the contact by the mating end, insert the
contact—insulation barrel first—through the front of
the tool and into the appropriate crimp section.
i
Contact
(Typ)
This tool is provided with a crimp adjustment
feature. Initially, the crimp height should be
verified as specified in Figure 4. Refer to Section
6, CRIMP HEIGHT INSPECTION, and Section 7,
CRIMP HEIGHT ADJUSTMENT, to verify crimp
height before using the tool to crimp desired
contacts.
Locator in
Wire Stop Slot
Note:
Wire
Inserted
to Stop
Not to Scale
Strip
Length
Wire
Seal
408-4344
3
of 5