58238-1 Tyco Electronics, 58238-1 Datasheet - Page 2

• Manufacturer Part Number: 58238-1
• Description: DIE SET SHELL SIZE 4-5 .375-.435
• Manufacturer: Tyco Electronics
• Series: AMPLIMITE®r
• Type: Crimpersr

Specifications of 58238-1

• Connector Type: Ferrule
• Crimp Handle: 543344-1
• Crimp Or Cable Size: 0.375" ~ 0.435" (9.53mm~11.05mm) Dia
• Lead Free Status / RoHS Status: Not applicable / Not applicable

See Figure 3 for a properly crimped ferrule.
2
Crimping Die Assembly 58238-1
of 4
4. Remove connector from die assembly and
inspect the crimped ferrule according to the
requirements outlined in the appropriate application
specification:
114–40008
114–40030
C IMPED
FE ULE
CABLE
AMPLIMITE HDE–20 Connector
Shielding Hardware Kits With and
Without Enclosure
AMPLIMITE HDP–20 and
Economy Crimp Snap
Subminiature D Commercial
Connectors
Figure 3
CONNECTO
BODY CLEA
OF DIES
SHIELDED
AMPLIMITE
CONNECTO
Tyco Electronics Corporation
Figure 2
5. MAINTENANCE AND INSPECTION PROCEDURE
The die assembly is inspected prior to shipment,
however, Tyco Electronics recommends that the die
assembly be inspected immediately upon arrival.
Tyco Electronics recommends that a maintenance
and inspection program be performed periodically to
ensure continued reliability of the die assembly. The
inspection frequency should be based on the amount
of use, working conditions, operator training and skill,
and established company standards.
5.1. Daily Maintenance
1. Remove accumulated dust, moisture, and other
contaminants with a clean, soft brush or lint–free
cloth. Do NOT use hard or abrasive objects that
could damage the dies.
2. Make sure dies are protected with a THIN coat
of any good SAE No. 20 motor oil. Do NOT oil
excessively.
3. When die assembly is not in use, mate and
store them in a clean, dry area.
STATIONA Y
DIE
F ONT PA T OF
FE ULE IN B AID
C IMPING SECTION
OF DIE
08-92 3
ev
C