2063778-2 Tyco Electronics, 2063778-2 Datasheet - Page 3

• Manufacturer Part Number: 2063778-2
• Description: CONN HAND TOOL DIE 22-18AWG
• Manufacturer: Tyco Electronics
• Series: Pro-Crimper™ IIIr

Specifications of 2063778-2

• Connector Type: Hermophroditic Blade & Receptacle
• Crimp Handle: 2063778-1-ND
• Crimp Or Cable Size: 18-22 AWG
• For Use With: 2058302-2 - CONN SOCKET CONTACT 18-22AWG TIN2058301-2 - CONN BLADE CONTACT 18-22AWG TINA99898 - HAND TOOL PRO-CRIMPER III W/DIE
• Lead Free Status / RoHS Status: Not applicable / Not applicable

5. CRIMPING PROCEDURE
Refer to the table in Figure 1 and select wire of the
specified size and insulation diameter. Strip the wire
to the length indicated in Figure 1, taking care not to
nick or cut wire strands. Select an applicable contact
and identify the appropriate crimp section according
to the wire size markings on the tool. Refer to
Figure 3 and proceed as follows:
Rev
PRO-CRIMPER III Hand Tool Assembly 2063778-1
4. Slightly loosen the nut that holds the locator
assembly onto the tool frame.
5. Move the contact support as required to
eliminate the bending of the contact.
6. Tighten the nut and close the handles until the
ratchet releases.
7. Remove and inspect the contact.
8. Make another sample crimp. If the contact is
straight, tighten the contact support screw. If the
contact is still being bent during crimping, repeat
the adjustment procedure.
NOTE
1. Hold the tool so that the back (wire side) is
facing you. Squeeze tool handles together and
allow them to open fully.
A
i
Tyco Electronics Corporation
Wire
Figure 3
CAUTION
2. Holding the contact by the mating end, insert the
contact — insulation barrel first — through the front
of the tool and into the appropriate crimp section.
3. Position the contact so that the mating end of
the contact is on the locator side of the tool, and so
that the open “U” of the wire and insulation barrels
must face the top of the tool. Place the contact up
into the nest so that the movable locator drops into
the slot in the contact. Refer to Figure 3. Butt the
front end of the wire barrel against the movable
locator.
4. Hold the contact in position and squeeze the
tool handles together until ratchet engages
sufficiently to hold the contact in position. Do NOT
deform insulation barrel or wire barrel.
5. Insert stripped wire into contact insulation and
wire barrels until it is butted against the wire stop,
as shown in Figure 3.
6. Holding the wire in place, squeeze tool handles
together until ratchet releases. Allow tool handles
to open and remove crimped contact.
NOTE
7. Check the contact’s crimp height as described in
Section 6, CRIMP HEIGHT INSPECTION. If
necessary, adjust the crimp height as described in
Section 7, CRIMP HEIGHT ADJUSTMENT.
Contact
(Typ)
!
i
Wire Inserted
to Stop
Locator in
Wire Stop
Slot
408-10290
3
of 5